Aiwa AWP-ZP5 - Manual (Page 8)

8 GB
2 Connect the FM and AM antennas.
Set up the AM loop antenna, then connect
it.
Note
Keep the antennas away from the speaker cords.
3 For models with a voltage selector, set
VOLTAGE SELECTOR to the local
power line voltage.
Refer to the print on your system’s
VOLTAGE SELECTOR for available
settings.
4 Connect the power cord to a wall
outlet.
The demonstration appears in the display.
When you press ?/1, the system turns on
and the demonstration automatically ends.
If the plug does not fit the wall socket,
detach the supplied plug adaptor (only for
models equipped with an adaptor).
Inserting two R6 (size AA)
batteries into the remote
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
AM
LOOP
FM
75 Ω
(CO
AXIAL)
Extend the FM lead antenna horizontally
AM loop antenna
When carrying this system
Perform the following procedures to protect
the CD mechanism. Use buttons on the unit
for the operation.
1
Make sure that the disc is removed from
the system.
2
Press FUNCTION repeatedly to switch
the function to CD.
3
Hold down Z and then press M>
until “STANDBY” appears.
After “STANDBY” disappears, then
“LOCK” appears.
4
Unplug the power cord.