Aiwa AWP-ZP5 - Manual (Page 30)

30 GB
Should you encounter a problem with your
system, do the following:
1
Make sure the power cord and speaker
cords are correctly and firmly connected.
2
Find your problem in the troubleshooting
checklist below and take the indicated
corrective action.
If the problem persists after doing all of the
above, consult your nearest Aiwa dealer.
General
The display starts flashing as soon as you
plug in the power cord even though you have
not turned on the system (see step 4 of
“Hooking up the system” (page 7)).
• Press DISPLAY twice while the system is off. The
demonstration disappears.
“– –:– –” appears in the display.
• A power interruption has occurred. Set the clock
(page 9) and timer settings (page 19) again.
The clock setting/radio presetting/timer is
canceled.
• Redo the following:
– “Setting the clock” (page 9)
– “Presetting radio stations” (page 13)
– “Falling asleep to music” and “Waking up to
music” (page 18)
There is no sound.
• Press VOLUME + (or turn VOLUME control on
the unit clockwise).
• Make sure the headphones are not connected.
• Check the speaker connections (page 7).
• The system is in pause mode. Press N (or CD
N on the unit) to return to normal play mode.
Personal computer sounds are heard when
functions other than PC are selected (except
for AWP-ZP1).
• Set PC Mixing to off.
There is severe hum or noise.
• Move the system away from the source of noise.
• Connect the system to a different wall outlet.
• Install a noise filter (commercially available) to
the mains line.
The timer cannot be set.
• Set the clock again (page 9).
The timer does not function.
• Activate the timer and “ c PLAY” lights up in the
display (page 19).
• Check the timer setting and set the correct time
(page 19).
• Cancel the Sleep Timer function (page 18).
• Make sure the clock is correctly set.
Troubleshooting
Problems and remedies
When the ?/1 indicator flashes
Immediately unplug the power cord and
check the following items.
• If your system has a voltage selector, is the
voltage selector set to the correct voltage?
Check the voltage for your region, then
make sure the voltage selector is set
correctly.
• Are the + and – speaker cords short-
circuited?
• Are you using the supplied speakers?
• Is anything blocking the ventilation holes
on the rear of the system?
Check all the above items and fix any
problems found. After ?/1 indicator stops
flashing, reconnect the power cord and turn
on the system. If the indicator still flashes, or
if the cause of the problem cannot be found
even after checking all the above items,
consult your nearest Aiwa dealer.