Aiwa AWP-ZP5 - Manual (Page 15)

T
une
r
15 GB
To change the AM tuning interval
(except for European model)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding M>
on the unit, press ?/1 on the unit. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the same
procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode (page 20).
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power failure
occurs.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 13).
1
Press TUNER BAND (or FUNCTION
repeatedly) to switch the function to
tuner.
2
Press TUNER BAND repeatedly to
select “FM” or “AM”.
3
Press TUNING MODE repeatedly until
“PRESET” appears in the display.
4
Press . or > repeatedly to select
the desired preset station.
Listening to non-preset radio
station
— Manual Tuning
1
Press TUNER BAND (or FUNCTION
repeatedly) to switch the function to
tuner.
2
Press TUNER BAND repeatedly to
select “FM” or “AM”.
3
Press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear from
the display.
4
Press TUNING + or – repeatedly to tune
in the desired station.
Note
When tuner function is selected as the current function
and CD is pressed to select CD during “CD POWER
OFF”, it may take some time to switch the function
(page 14).
Listening to the radio
continued