American Standard 3475.5 User Manual

Page 4

INSTALL HANDLES

CHECK DRAIN CONNECTIONS

TEST INSTALLED FITTING

With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.

Operate both HANDLES (1) to flush water
lines thoroughly.

Rotate TRANSFER VALVE (5) from rim wash to
spray several times to check operation.

Pull up POP-UP KNOB (3) and fill Sink with water. Check
that DRAIN STOPPER (4) makes a good seal and retains
water in Bidet. If STOPPER (4) does not seal properly,
please refer to “Troubleshooting Guide” in these instructions.

Push POP-UP KNOB (3) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.

M 9 6 8 6 7 7

Rev. 1.1

SPRAY

OUTLINE OF BIDET

CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER. DRY
WITH A SOFT COTTON FLANNEL
CLOTH.

DO NOT: DO NOT CLEAN THE
PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.

LEVER HANDLE

Turn HANDLE STEM (1) to "OFF" position.

Place the HANDLE ADAPTER (2) on the HANDLE STEM (1). Install the

ADAPTER SCREW (3) and tighten securely.

Position LEVER HANDLE (4) and place on ADAPTER (2). Install the

HANDLE SCREW (5) and tighten securely.

SERVICE

To change direction of handle
rotation, proceed as follows:

If spout drips, operate handles several

times from OFF to ON position. Do not

force - handles turn only 90˚.

Loosen HANDLE SCREW (1) .

Turn VALVE to OFF position.

Pull HANDLE (2) off ADAPTER (4). Loosen ADAPTER

SCREW (3) and pull off ADAPTER (4).
Remove SPRING CLIP (7). Lift STOP WASHER (5),
turn 90

° and replace. Replace SPRING CLIP (7).

Tighten HANDLE SCREW (1).

Reinstall ADAPTER SCREW (4) and LEVER HANDLE (2).

90˚