American Standard 3475.5 User Manual

Page 10

M 9 6 8 7 9 6 R e v. 1 . 1

CHECK DRAIN CONNECTIONS

TEST INSTALLED FITTING

With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.

Operate both HANDLES (1) to flush water
lines thoroughly.

Rotate TRANSFER VALVE (5) from rim wash to
spray several times to check operation.

Pull up POP-UP KNOB (3) and fill Bidet with water. Check
that DRAIN STOPPER (4) makes a good seal and retains
water in Bidet. If STOPPER (4) does not seal properly,
please refer to “Troubleshooting Guide” in these instructions.

Push POP-UP KNOB (3) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.

SPRAY

American Standard’s EverClean
finish will wipe clean with a soft,
dry cloth.
A soft cloth with clean water
may also be used, if desired.
No additional cleaning products
are required.

DO NOT USE: Soaps, acid,
polish, abrasives, harsh
cleaners, or a cloth with a
coarse surface.

EverClean™ Finish
Care Instructions

INSTALL HANDLES (Lever)

INSTALL HANDLES (Acrylic)

Turn HANDLE STEM (1) to "OFF"

position.

Place the ACRYLIC HANDLE (2)

on the HANDLE STEM (1).

Install the HANDLE SCREW (3)

and tighten securely.

Push in INDEX BUTTON (4).

Turn HANDLE STEM (1) to "OFF"

position.

Place the HANDLE ADAPTER (2)

on the HANDLE STEM (1).

Install the ADAPTER SCREW (3)

and tighten securely. Position

LEVER HANDLE (4) and place

on ADAPTER (2).

Install the HANDLE SCREW (5)

and tighten securely with hex

wrench supplied.

SERVICE

If spout drips, operate handles several

times from OFF to ON position. Do not

force - handles turn only 90˚.

To change direction of handle
rotation, proceed as follows:

Loosen HANDLE SCREW (1) .

Turn VALVE to OFF position.

Pull HANDLE (2) off ADAPTER (3). Loosen ADAPTER

SCREW (4) and pull off ADAPTER (3).

Turn ADAPTER (3) 90˚ in a way that flat in ADAPTER (3)

catches on the other FLAT on VALVE STEM (5).

Tighten HANDLE SCREW (1).

Reinstall ADAPTER SCREW (4) and LEVER HANDLE (2).