Abocom 802.11b/g Portable Router WAP2102 - Manual (Page 28)

25
DHCP
Disable: Select to disable this Router to distribute IP Addresses
(Disabled).
Server: Select to enable this Router to distribute IP Addresses
(DHCP Server). And the following field will be activated for
you to enter the starting IP Address.
DHCP Client Range The starting address of this local IP network address pool. The
pool is a piece of continuous IP address segment. Keep the
default value 192.168.1.1 should work for most cases.
• Maximum: 253. Default value 253 should work
for most cases.
Note: If “Continuous IP address poll starts” is set at
192.168.1.1 and the “Number of IP address in pool” is 253,
the device will distribute IP addresses from 192.168.1.1 to
192.168.1.253 to all the computers in the network that request
IP addresses from DHCP server (Router)
Show Client Click to show Active DHCP Client Table.
Refresh: Click this button to refresh the table.
Close: Click this button to close the window.
DNS Server Enter the Domain Name Service IP address.
Apply Changes After completing the settings on this page, click to save the
settings.
Reset Click to restore to default values.
Other
Upgrade Firmware