American Audio UCD-200 - Manual (Page 7)

• Jog Wheel Pitch Bend (b)
• Single or Continuous Play
• Selectable Time Display
• Auto Cue
• Flip Flop ™ (Relay Playback) (c)
• Pitch Control and Bend
(+/-4%, +/-8%, or +/-16%, & 100%*)
• Dual USB Slots for MP3 Playback
*100% Pitch Bend/Pitch Slider is for CDs only
© American Audio ® - www.americanaudio.us - UCD-200 Instruction Manual Page 7
MAIN FEATURES
(a) 60 SECOND TRANSPORT PROTECTION: The CD transport tray will automatically close if left open for more than 60 sec-
onds. If a CD is left in the tray it will immediately cue.
(b) JOG wHEEL PITCH BEND: During normal playback, the jog wheel acts as a momentary pitch bend. Turing the wheel in a
clockwise direction will increase the speed and turning the wheel in a counter-clockwise direction will decrease the speed.
(c) FLIP-FLOP™: For FLIP-FLOP™ results you must use both drives. Connect your UCD-200 as described in the set-up section
of this manual. This feature will start the next player side once one player side has ended. For example, if drive one is playing
and it ends, drive two will instantly begin to play. you may set FLIP-FLOP™ to play track to track or music source device to
music source device. For more information on this feature, see FLIP-FLOP™ on page 21.
• 8 Times Over Sampling 1 Bit D/A Converter
• 60 Second Transport Protection (a)
• Pitch Display
• Reads CD and CD-R Media
• Repeat in Single Mode
• 4 Speed Search
• Database Builder
IMPORTANT SD CARD INFORMATION & SET-UP
SD CARD INFORMATION:
• Make sure your SD Card only has MP3 files on it
• Do Not have any other file type on your SD Card; no photo files, etc...
• American Audio SD Players can read SD HC (High Capacity) Cards up to 32GB
PlEASE NOTE:
For higher quality MP3 files (more than 128 kbps) American Audio recommends "High Speed"
SD Cards. Using high speed cards will ensure the best performance with your American Audio
SD Player.
USB INFORMATION:
• Make sure your USB device has only MP3 files on it. There cannot be any other type of files
on your USB device, NO photo files, etc...
• If you are using a SD Card via USB SD Card reader, you must remove the USB SD Card
reader first to change SD Card's. Please do not remove the SD Card from the USB SD Card
reader while the USB card reader is still connected to the unit.
• Only supports FAT/FAT32 formatted devices.