American Audio UCD-200 - Manual (Page 19)

© American Audio ® - www.americanaudio.us - UCD-200 Instruction Manual Page 19
Holding down or tapping on the (+) PITCH
BEND BUTTON (13) will provide a speed
bump in the playback pitch.
BASIC OPERATIONS (CONT)
10. PITCH BEND:
This function will momentarily increase or decrease a tracks playback speed. There are two ways to operate
this function with the (-) & (+) PITCH BUTTONS (13) or with the JOG wHEEL (19). The maximum pitch bend
percentage allowed is +/- 16%. The pitch bend function will work in conjunction with the PITCH SLIDER (5)
pitch setting.
PITCH BEND BUTTONS (14):
The (+) PITCH BEND BUTTON (13) will provide a speed bump and the (-) PITCH BEND BUTTON (13) will pro-
vide a slow down. The maximum range of the PITCH BEND BUTTONS is 100%. The extent to which the speed
changes is proportionate to the amount of time the button is pressed. For example, if the (+) PITCH BEND
BUTTON (13) is held down continuously, the speed will increases and will continue to increase until reaches a
maximum of 16% speed gain. when you release the (+) PITCH BEND BUTTON (13) the speed will automati-
c
ally return to it’s previous speed.
Holding down or tapping on the
(-) PITCH BEND BUTTON (13) will
provide a slow down in the play-
back pitch.
Figure 14
Figure 15
JOG WHEEl (19):
The JOG wHEEL (19) will temporarily bend the pitch
if a track is in play mode Rotating the wheel in a
clockwise direction will increase your track pitch and
rotating the wheel in a counter-clockwise direction
will slow your track pitch. The speed you rotate the
JOG wHEEL (19) will determine pitch bend percent-
age (%).
Figure 13