PA Industries Edge Servo Roll Feed with SFI SRF-100/125/200/300/400/500/600 - Manual (Page 9)

ULTRA EDGE SERVO ROLL FEED 2 /09/2002
9
Max length is a Length limit and protects against accidental entering extra digits, for example: 100 inch instead of 10
inch. It is a numeric entry, with a range of 0 to 999999. (This value is factory set to 20.000.)
NOTE: To exit setup editing at any time, press the “OPER” key. Changes will be saved.
4 HOW TO …
4.1 HOW TO EDIT “OPERATOR” PARAMETERS
Position cursor next to desired parameter, enter appropriate value, and press the “ENTER” key.
Locate the OPERATOR screen, position cursor next to desired parameter, enter appropriate value, and press the
“ENTER” key.
L e n g t h 1 . 0 0 0
C o u n t C o n t . R u n
L e n g t h A d j u s t m e n t <
P r e s s O P E R f o r n e x t
Press “OPER” key to open next screen. Position cursor next to desired parameter, enter appropriate value, and press
the “ENTER” key. Enter “0” for Decel to use Accel value or an actual desired value.
S p e e d 7 2
A c c e l 4 0 0 . 0
D e c e l 4 0 0 . 0
P r e s s O P E R f o r n e x t
Press “OPER” key to open next screen. Position cursor next to desired parameter, enter the appropriate value, and
press the “ENTER” key.
D w e l l 0
P r e s s O P E R f o r n e x t
4.2 HOW TO EDIT “SETUP” PARAMETERS
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position and OPERATOR screen is displayed. If the current screen is not OPERATOR one then press the
“OPER” key to bring it up.
Press “SETUP” key three times, position cursor next to desired parameter, enter in new value, and press the
“ENTER” key.