Motec operation 19, Diagnostics, Ltc temp – MoTeC LTCN User Manual
Page 19: Can address, Collect
MoTeC
Operation
19
Diagnostics
The Diagnostics column shows faults and diagnostic information for all
connected LTCs.
Diagnostic
Description
Heater short
circuit (GND)
A short circuit to ground has been detected in the
heater wiring
Heater short
circuit (Batt+)
A short circuit to battery+ has been detected in the
heater wiring
Heater open
circuit
An open circuit has been detected in the heater wiring
Failed to achieve
heat
The measured sensor temperature is not responding
to sensor heating. This fault may indicate a fault with
the sensor wiring.
Sensor short
circuit
A short circuit has been detected in the sensor wiring
Corrupt Firmware The LTC firmware is corrupt. Upgrade the firmware to
restore operation.
Incompatible
Firmware
The LTC firmware is incompatible with LTC Manager.
Upgrade the firmware to restore operation.
LTC Temp
The LTC Temp column shows live internal temperature readings of all
connected LTCs.
Note: The temperature column shows the temperature of the LTC unit, not the
sensor temperature.
CAN Address
The CAN Address column shows the configured CAN addresses (in hex) of all
connected LTCs.
To configure the CAN addresses see
Setup
.
Collect
The Collect column shows the configured CAN Collect functionality of all
connected LTCs. To configure the CAN Collect functionality see
Setup
.
A configured CAN Collect Master device is always shown as Master (1).