Connections, Configuring inputs, Configuring outputs – MoTeC C185 User Manual

Page 27: Configuring communications

Configuration

MoTeC

Connections

Configuring Inputs

• On

the

Connections menu, click Devices

• Select the device (e.g. C185) and then click the Input pins tab

This will list all inputs available for this product

Note: Some inputs require the 52 I/O Upgrade to make them available.
See C185 Upgrades

• Select the input and click Channel (or double click the input)
• Assign a measurement channel to the input and click OK
The channel needs to be calibrated using one of two options
• Select

Load Cal if a pre-defined calibration is available

• Double-click the input to enter a calibration
Other tasks:
• Change Cal – to change the calibration
• Spd Levels – only for speed inputs
• Settings – to set default

Configuring Outputs

• On

the

Connections menu, click Devices

• Select device (e.g. C185) and then click the Output Pins tab to list all

outputs available for this product

Note: Some outputs require 52 I/O Upgrade to make them available. See
C185 Upgrades.

• Select the output and click Change (or doubleclick the output)
• Select a mode to make appropriate settings available
• Follow the directions on the screen and when all settings are done click

Configuring Communications

• On

the

Connections menu, click Communications

• Select an available communications section (CAN or RS232)
• Click

Select and choose one of the available communications templates