DE-STA-CO 80RDM - Manual (Page 9)

3. There should be no looseness in
any dwell.
If there is, loosen screws (16) and
rotate tops of cartridges (5) to
slightly preload the loosest dwell.
Tighten screws (16).
4. There should be even preload in
different motions.
If not, remove output shaft/fol-
lower wheel (2) and adjust shims
(11) to move the output shaft/
follower wheel (2) in or out.
C. Matchmark cartridges (5) with housing
(1) to retain proper adjustment.
D. Final assemble cartridges (5) as follows:
1. Remove one cartridge (5) and
shims (13).
2. Apply Mobilith AW-2 Grease in
bearing cup (15).
3. Install o-ring (28) on cartridge (5).
4. Install shims (13) on cartridge (5).
5. Apply a bead of silicone around
the flange of bearing cartridge
(5).
6. Apply a dab of silicone to the
holes in housing (1) for screws
(16).
7. Install cartridge (5), install screws
(16), align matchmarks to obtain
proper cam setting and tighten
screws (16).
8. Remove opposite cartridge (5)
and shims (13).
9. Apply Mobilith AW-2 Grease to
bearing cone (15).
10. Install o-ring (28) on cartridge (5).
11. Install shims (13) on cartridge (5).
12. Apply a bead of silicone around
the flange of bearing cartridge
(5).
13. Apply a dab of silicone to the
holes in housing (1) for screws
(16).
14. Install cartridge (5), install screws
(16), align matchmarks to obtain
proper cam setting and tighten
screws (16).
15. Drill a hole through each car-
tridge (5) and into housing (1)
and install a roll pin to prevent the
cartridge from rotating.
8. OIL SEAL INSTALLATION
A. Install new oil seals (17) as described in
the "General Service Manual".
9. OPTIONAL THRU HOLE TUBE INSTALLA-
TION
A. Position thru hole tube (8) in the bore of
housing (1) and tap into output shaft/
follower wheel (2).
NOTE: One end of the thru hole tube
(8) has a larger OD. The larger OD must
be installed into output shaft/follower
wheel (2).
B. Install new oil seal (25) into housing (1)
as described in the ‘’General Service
Manual‘’.
10. OPTIONAL STATIONARY OUTPUT SHAFT
INSTALLATION
A. Install quad ring (10) and o-ring (18) on
stationary output shaft (24).
B. Tap optional stationary output shaft (24)
into housing (1).
C. Install the four screws (31).
8