DE-STA-CO 80RDM - Manual (Page 4)

OIL SEAL REMOVAL
The only repair possible without disassembly of the index drive is replacement of oil seals. To
remove oil seals, drill a number of holes into the case of the seal. The seal may then be removed
with a pointed tool. Be sure to remove all metallic chips created during the drilling of removal
holes. A new seal may be installed as outlined in the "Oil Seal Installation Recommendations"
section of the "General Service Manual".
SPARE PARTS KIT
CAMCO offers a Spare Parts Kit for all CAMCO index drive models CAMCO builds. These kits
include oil seals, bearings, shims and cam followers. These are components that will most likely
require replacement during repair of your index drive.
A complete list of components supplied in the Spare Parts Kit can be found in the parts list located
in the rear of this manual. The asterisk behind the item number indicates those parts supplied with
the Spare Parts Kit.
BEFORE STARTING
Before starting disassembly of your CAMCO unit you should read and review the following instruc-
tions. These provide important information on parts and procedures necessary to successfully
complete your repair.
Comply with all Warnings and Cautions.
Read the "Trouble Shooting Guide" section of your "General Service Manual" before disassembling
CAMCO units. CAMCO recommends returning defective equipment for inspection and repair
whenever possible.
CAMCO uses Loctite to secure all screws and setscrews. If you encounter a fastener that is
difficult to remove, apply heat to the screw and remove while still warm.
3