BatteryMINDer 24041 - Manual (Page 17)

BatteryMINDer ® Models 12248 & 24041
Rev. C-082713 Page 17 P/N VDC12248/24041-MNL
9. Note: If attempting to charge more than one battery at a time it is
very likely the charger will need to be restarted as described in order
to completely charge multiple batteries.
10. After carefully reading these instructions and Troubleshooting (pgs. 21 -
22) sections, should you still have questions, please e-mail our technical
support department at: [email protected].
11. Allow up to 3 business days for a detailed response to your questions.
Always identify the model number of the product and revision letter of this
manual contained on this page below. Without this information we may
not be able to assist you correctly.
At-the-Battery Temperature Sensor (ABS-248)
This temperature sensing system is made up of two components.
The thermal sensor with ring terminal and male plug with dust
cover with extension cord attached. This cord then attaches
directly to the mating female receptacle located on the charger.
Attaching the temperature sensor with extension cord:
Your first choice should be to connect it to the Positive (+) or Negative (-)
post (clamp / screw) of the battery. This is the best location to sense the
temperature of the battery.
The second choice is to place it as close to the battery as possible. Attachment
of the sensor to the side or top of battery is also a possible option, under the
right circumstances. Be careful to ensure it will not come loose in service.