BatteryMINDer 12248-A-ODY User Manual
Page 22

BatteryMINDer
©
Model 12248-A-ODY
Rev. D-050509
Page 22
P/N VDC12248-A-ODY-MNL
be so large it may require a second full recharge. Repeat
recharge. 3. If recharging multiple batteries, 2 or more
complete recharge cycles may be needed. Repeat full
recharge. If still
RED
-
blinking
, you may need to charge
each battery separately.
Problem:
Battery Condition Indicator lights
Yellow
(After battery
has been completely charged)
Solution:
Battery still has an unacceptable level of sulphation and must
stay connected to charger and remain in Maintenance-Float
mode (
GREEN
blinking indicator) for 72 hours or longer. Then
stop charger by pressing STOP/RESTART button and observe
Indicator. If still
Yellow
repeat (up to 3 full cycles) or until
indicator lights
GREEN
.
Problem:
Battery Condition Indicator lights
Yellow
(May be several
causes)
(Before battery is completely charged)
Solution.
Battery can be weak due to sulphation, self discharge or was
very deeply discharged. Attempt a full recharge and recheck
after completion. If still
Yellow
follow procedure for (After
battery has been completely charged.)
Problem.
Charger Indicators show battery is fully charged, but fails to
provide good cranking, lighting or equipment run time, as it did
when newer.
Solution.
Battery may be defective. Have it tested by a qualified source.