Neff K3990X7 - Manual (Page 41)

41
Aligning the appliance
To ensure that the appliance functions
correctly, it must be set level with a
spirit level.
If the appliance is not level, water may
flow out of the ice maker, ice cubes
may be irregular or the doors may not
close properly.
S Place the appliance in the designated
location.
S To prevent the appliance from rolling
away, unscrew the front and rear feet
until they have good contact with the
floor.
S Rotate front and rear feet until the
appliance is aligned exactly. Use the
doors as a reference point!
Freezer compartment door is deeper:
Refrigerator compartment door is
deeper:
If the previous steps for aligning
the door are not adequate:
S Loosen 3 hinge screws. Do not
completely unscrew the screws!
S Place the wrench on the adjusting
screw.
- To raise a door:
Rotate the wrench clockwise.
- To lower a door:
Rotate the wrench
antiĆclockwise.
Note:
Due to the weight of the appliance and
the food load in the door, the refrigeĆ
rator compartment door may incline,
even if the appliance itself is level.
The door gap is not the same at the top
and bottom.
S Remove cap from the upper hinge
of the refrigerator compartment door.
S Loosen hinge screws. If required,
use a socket wrench (A/F 10). Do not
completely unscrew the screw!
S Adjust the inclination of the
refrigerator compartment door.
S Tighten the hinge screws.
S Insert the cap.
en