Atec Tektronix-TCP0150 - Manual (Page 2)

Datasheet
Characteristics
Warranted
Characteristic Description
Bandwidth DC to ≥20 MHz (-3 dB). Derate with Frequency. See
Figure 1. (Calculated from Rise Time BW = .35/Rise
Time)
Rise Time ≤17.5 ns
Max RMS Current 150 A
Max Peak Pulse Current 500 A
Minimum Sensitivity 5 mA (on oscilloscope’s 1 mV/div setting)
AC Coupling (on oscilloscopes that support AC/DC
coupling)
Current Ranges 25 A and 150 A
Max Bare-wire Voltage 600 V
RMS
CAT I and II
300 V
RMS
CAT III
Typical
Characteristic Description
DC Accuracy ±1% Typical
3% Warranted
Max Amp-second Product
25 A Range 3,000 Aµs
150 A Range 15,000 Aµs
0.03 Ω at 1 MHz
0.075 Ω at 5 MHz
.125 at 10 MHz
Insertion Impedance
.3 at 20 MHz
Signal Delay ≈ 21 ns
Displayed RMS Noise ≤500 μA
RMS
(probe only)
Environmental
Characteristic Description
Temperature
Operating 0 ºC to +50 ºC
Nonoperating -40 ºC to +75 ºC
Humidity
Operating 5% to 95% RH (Relative Humidity) at up to +30 ºC
5% to 85% RH above 30 ºC up to +50 ºC,
noncondensing
Nonoperating 5% to 95% RH (Relative Humidity) at up to +30 ºC
5% to 85% RH above 30 ºC up to +75 ºC,
noncondensing
Altitude
Operating Up to 2,000 meters (6,560 feet)
Nonoperating Up to 12,000 meters (40,000 feet)
Physical Characteristics
Dimension Meters Inches
Cable Length 2 meters 79 in.
Probe head size
Length 26.8 cm 10.55 in.
Width 4.1 cm 1.6 in.
Height 15.6 cm 6.13 in.
Max Conductor Diameter 21 mm x 25 mm 0.83 in. x 1.0 in.
Weight kg lb.
Shipping .7865 1.734
Power Requirements TCP0150 is powered directly by oscilloscopes
with the TekVPI interface
Recommended Oscilloscopes
Oscilloscopes with the TekVPI probe interface.
Note: For best probe support, download and install the latest version of the
oscilloscope software from www.tektronix.com
2 www.tektronix.com