Atec Thermonics-T-2600BV - Manual (Page 2)

T-2600BV SPECIFICATIONS
Temperature
Range: -30
°
C to +225
°
C at 100 psi air pressure
Accuracy: –1.0
°
C
Repeatability: –0.5
°
C
Stability: –0.5
°
C
Transition Time: 15 seconds from +100
°
C to -5
°
C.
Transition times measured after system
stabilization in cycle mode.
Controller: Microprocessor-based PID (Proportional
Integral Differential).
Fail-Safes: Snap disc thermostat, air pressure and
flow sensors, and thermocouples.
Soak Time: Programmable (0-999 seconds) in 1 sec-
ond increments.
DUT Sensor: K-type or T-type Thermocouple.
Operating
Environment:
20
°
C to 28
°
C.
Power
Standard: 110VAC to 120VAC, 1
Φ
, 15A, 50/60Hz
Optional: 220VAC, 1
Φ
, 10A, 50/60 Hz
Physical Characteristics
Height Width Depth Weight
in/cm in/cm in/cm lb/kg
8/20 18/46 22/56 50/23
Compressed Air Input Requirements
Input Pressure: 90 to 120 PSIG (6.4 to 8.5 kg/ cm2)
NOTE: lower air pressure degrades cold
specification. For best results, supply an
input air pressure of 90 to 120 PSIG.
Flow Rate: 15 SCFM (7.15 liters/sec)
Quality: Clean, dry air; free of oil, moisture and
particles
Dew Point: Less than -40
°
C at 90 PSIG. (This can be
achieved using Thermonics T-ADF/BV air
dryer.)
Remote Control
IEEE-488, RS-232C and standard tester interface for
start-test and end-of-test signals.
Rear Panel of T-2600BV
1288 Reamwood Avenue
S unnyvale , California 94089-2233
(408) 542 - 5900 Fax: (408) 542 - 5910
E-mail: [email protected]
Specifications subject to change without notice. 1/15/03
E:\t2600bv\marketing\26bvsheet3.qxd
X Y R
(in/cm) (in/cm) (in/cm)
Min: 6/15 0/0 9/23
Max: 15/38 12/30 24/61
(Air Temp.)
A Test Enterprises Company