Atec Solar-9354-1 - Manual (Page 2)

MODEL 9354-1 UNIVERSAL TRANSIENT GENERATOR
AVAILABLE ACCESSORIES
Variable and Step Frequency Modules. Provides
tunable frequencies for injection of damped
sinusoidal wave forms from 10 KHz to 100 MHz
when used with Model 9354-1. Five individual
modules waveforms cover the entire frequency
range required by MIL-STD-461D. Detailed
information provided on separate data sheet.
Type 9335-2 Universal Coupling Device. An
inductive injection device that provides voltage
and current transfer of 1:1, 1:1.5 and 3:1 voltage
step-up (current step-down) as well as 2:1 voltage
step-down (current step-up). For maximum power
transfer, these ratios are selected by connecting
to one of the four BNC connectors. This device,
through its various connector ports, provides a
better impedance match or power transfer, higher
open circuit voltages, or higher short circuit
currents. Useable for cable current injection from
10KHz to 10 MHz. Detailed information provided
on separate data sheet.
Type 9719-1N Injection Probe. Provides the
required current leveles of MIL-STD-461D and E,
method CS116 throughout the entire frequency
range of 10 KHz to 100 MHz.
Type 9357-1 Calibration Fixture. Calibration
fixture provides a 50 ohm characteristic
impedance based on the dimensions of the
Type 9335-2 Universal Coupling Device
and Type 9719-1N Injection Probe. The fixture
maintains a low standing wave ratio from 10 KHz
to 100 MHz in a 50 ohm circuit.
Type 9142-1N Injection Probe. Used to inject
current on cables from 1 MHz to 100 MHz.
Type 9125-1 Calibration Fixture. Calibration
fixture for use with Type 9142-1N Injection
Probe.
Type 9123-1N Current Probe. Used to monitor
injected pulses. Frequency range from 10 KHz to
500 MHz.
Type 9410-1 50 ȉ/50ȉ and Type 9454-1
600 ȉ/50ȉ High Voltage Attenuators. Provides
40 dB attenuation from 10 KHz to 100 MHz.
Protects oscilloscope from high voltage damage
when verifying the output pulses of the
Model 9354-1. The Type 9454-1 provides a high
impedance to the oscilloscope for making
measurements of open circuit output pulses.
Type 6220-4 High Voltage Audio Isolation
Transformer. When connected in series with the
power lead under test, provides twice the open
circuit voltage or twice the short circuit current
for the 10 KHz and 100 MHz damped sinusoid
waves and the 6.4
ȖS and 70 ȖS double
exponential pulses. Capable of handling up to
4000 volts.
Type 9616-1 Injection Clamp. Provides coupling
for high voltage pulses produced by the Model
9354-1. Meets the inductive indirect injection
device requirement of MIL-STD-462, notice 5,
method CS10 and CS11. Enables injection of 70
ȖS double exponential pulses without need for
direct connection.
SPECIFICATIONS
DAMPED SINUSOID PULSES
(NOTE: MEASUREMENT OF SHORT CIRCUIT CUR-
RENTS ARE LIMITED BY THE X
L
OF THE CIRCUIT.
ALL VALUES ARE CALCULATED.)
10 KHz
Open Circuit Voltage . . . . . . . . . . . . . . . . . . . . . .30 V.
Calculated Short Circuit Current . . . . . . . . .120 A.
Source Impedance . . . . . . . . . . . . . . . . . . . . .<0.25
ȉ
100 KHz
Open Circuit Voltage . . . . . . . . . . . . . . . . . . . . .300 V.
Calculated Short Circuit Current . . . . . . . . . .120 A.
Source Impedance . . . . . . . . . . . . . . . . . . . . . .<2.5
ȉ
1 MHz
Open Circuit Voltage . . . . . . . . . . . . . . . . . . . .3200 V.
Calculated Short Circuit Current . . . . . . . . .128 A.
Source Impedance . . . . . . . . . . . . . . . . . . . . . .<25
ȉ
10 MHz
Open Circuit Voltage . . . . . . . . . . . . . . . . . . . .3200 V.
Calculated Short Circuit Current . . . . . . . . .128 A.
Source Impedance . . . . . . . . . . . . . . . . . . . . . .<25
ȉ
30 MHz
Open Circuit Voltage . . . . . . . . . . . . . . . . . . . .1000 V.
Calculated Short Circuit Current . . . . . . . . . . .20 A.
Source Impedance . . . . . . . . . . . . . . . . . . . . . .<50
ȉ
100 MHz
Open Circuit Voltage . . . . . . . . . . . . . . . . . . . . .300 V.
Calculated Short Circuit Current . . . . . . . . . . . .6 A.
Source Impedance . . . . . . . . . . . . . . . . . . . . . .<50
ȉ
VOLTS
40
20
0
-20
-40
DAMPED SINUSOIDAL PULSE, 10 KHz INTO AN OPEN CIRCUIT.
0 ȖS 200 ȖS 400 ȖS 600 ȖS 800 ȖS
DAMPED SINUSOIDAL PULSE, (10 KHz) INTO AN OPEN CIRCUIT.
10