Atec Teseq-PA5740 - Manual

A d v a n c e d Te s t S o l u t i o n s f o r E M C
POWER AMPLIFIER/BATTERY SIMULATOR
PA 5740
Capacitive stability mode
High bandwidth up to 180 kHz
Fast slew rate
Ideal for use as synchronized
auxiliary channels required by
various EMC standards
Two gain settings for universal
use
Sense lines for cable voltage drop
compensation
Four quadrant operation
Banana output connector on both
the front and back of the
simulator
Battery simulators replace the vehicle battery in the test environment. These sources must fulfi ll
various criteria concerning power rating, voltage, slew rate, impedance, etc. depending on the particular
application. Bipolar current sources are specifi ed for in several cases. Pulse 2b, pulse 4, sine wave noise
and other complex simulations are realm of the PA 5740. Of course the amplifi er is also perfectly suited
for ISO 7637 compliant simulated conducted transient testing. Offering combinations of features that
exist in no other battery simulator, the PA 5740 series is the right product at the right price for your EMC
needs.
Designed specifi cally for automotive EMC testing, Teseq’s 42 V ready amplifi er sets the pace for auto-
motive battery simulation includingfeatures necessary for automotive immunity testing such as sense
wires for cable voltage drop compensation and several operating modes for stability with complex
automotive loads.
For more details, see the complete catalog “Automotive Electrical Disturbances”.
© February 2011 Teseq ®
Specifications subject to change without notice.
Teseq
® is an ISO-registered company. Its products
are designed and manufactured under the strict
quality and environmental requirements of the ISO
9001. This document has been carefully checked.
However, Teseq
® does not assume any liability for
errors or inaccuracies.
Teseq AG
Nordstrasse 11F 4542 Luterbach Switzerland
T + 41 32 681 40 40 F + 41 32 681 40 48
[email protected]
www.teseq.com
691-136A February 2011