Atec Teseq-Schaffner-ISN-T8-CAT6 - Manual (Page 2)

Mechanical specifications
Size (W x H x D): 105 x 65 x 110 mm³
Weight: approx. 550 g
Teseq GmbH
Landsberger Str. 255 · 12623 Berlin · Germany
T + 49 30 56 59 88 35 F + 49 30 56 59 88 34
[email protected]
www.teseq.com
82-248715 E02 June 2008
IMPEDANCE STABILIZATION NETWORK (ISN)
FOR UNSHIELDED BALANCED PAIRS
ISN T8-Cat6
Application
Pin-arrangement for EIA/TIA T568B
Pair 1/ Pair 2/ Pair 3/ Pair 4/
Pin 4,5 Pin 1,2 Pin 3,6 Pin 7,8
Token ring, ISDN basic rate access / S0 RJ45 X X
ISDN primary rate access (2Mbps) RJ45 X X
10BaseT, 100BaseTX RJ45 X X
100BaseT4, 100Base VG-AnyLan, 1000BaseT RJ45 X X X X
ATM, FDDI, TP-PMD RJ45 X X
IBM 3270 RJ45 X
ISN T8-Cat6 with view to the EUT con-
nection RJ45
ISN T8-Cat6
EUT connection
for RJ45 AE connection
for RJ45
RF connection for
measuring receiver or
immunity test system
The described ISN T8-Cat6 is appropriate for immunity tests of IEC 61000-4-6. Optional available are the
parts for the level setting (test set-up calibration) CAL U100 (150 Ω /50 Ω adapter), 2 x SAR T802 (common
mode adapter for RJ45) and TRA U150 (150 Ω termination).
Additional application
Delivery information
Part number Description
248715 ISN T8-Cat6
ISN for up to eight unshielded balanced lines for cable cat.6
97-248550 ISN T8-TC
Traceable calibration (ISO17025), order only with ISN T8/T8-Cat6
248580 CAS ISN
Calibration kit for ISN T8 and ISN T4
248631 CAS ISN extension for cat.6
Adapter parts for calibration of ISN T8-Cat6, required CAS ISN
239901 CAL U100
Universal calibration unit (150 Ω /50 Ω adapter)
242428 SAR T802
Calibration adapter part for ISN T8-Cat6 with RJ45 connector
(common mode adapter)
239903 TRA U150
Universal termination resistor 150Ohm AE side
*) The IEC/EN 61000-4-6 test set-up required 2x SAR T802.