C/n ratio testing • e, Options, Png7000 series – Atec Noise-Com-PNG7109 User Manual
Page 2: Png7000 series noise genera tors
![background image](/manuals/319526/2/background.png)
Once a CNR calibration has been performed, the ratio can
be changed using the internal precision attenuator to vary
the noise power without degrading accuracy. The output
noise power level is factory calibrated at a 0 dB attenuator
setting and is displayed in dBm/Hz.
Every front panel operation except instrument on/off is
programmable, and the user can create up to nine test
routines that can run automatically under program con-
trol. These routines can include delay times and loops, and
can be executed manually or via bus control. The routines
are easily written using the program key, and information
on the display guides the user through the next steps.
Applications:
•
C/N Ratio Testing
•
E
b
/N
o
Testing
•
AWGN
•
CCITT G.95
•
SONET
•
Data regenerators
•
Multiplexers
•
Hard disk drives
1 3
To order call 201-261-8797
OPTIONS
Option Number
Description
PNGopt01
SMA female input and output
PNGopt02
75 ohms input and output impedance
PNGopt03
230 VAC, 50 Hz
PNGopt04
Switch including up to 5 noise sources
PNGopt05
RS232 in addition to standard IEEE-488 interface
PNGopt06
127 dB signal attenuator in 1 dB steps
PNGopt07
DC coupled signal path (6 dB RF Loss)
PNG7000 SERIES
MODEL FREQUENCY
OUTPUT
CHARACTERISTICS
RANGE POWER (dBm)
Vrms
dBm/Hz
FLATNESS(dB)
PNG7105
1 MHz - 10 MHz
+3
0.316
-67
±0.25
PNG7107
10 MHz - 100 MHz
+3
0.316
-77
±0.25 / 40 MHz
PNG7108
10 MHz - 500 MHz
+3
0.316
-84
±0.25 / 40 MHz
PNG7109
10 MHz - 1 GHz
+3
0.316
-87
±0.25 / 40 MHz
PNG7110
10 MHz - 1.5 GHz
+3
0.316
-89
±0.25 / 40 MHz
PNG7111
1 GHz - 2 GHz
+3
0.316
-87
±0.25 / 40 MHz
PNG7112
10 MHz - 2 GHz
+3
0.316
-87
±0.25 / 40 MHz
PNG7000 SERIES
NOISE GENERA
TORS
Lab Windows Drivers available
from National Instruments
Rev Date 5/15/03