Atec IFI-SMC Series - Manual (Page 2)

SMC Solid State Amplifiers
80 – 1000 MHz • 10 Watts to 3000 Watts, Minimum Rated Power
Specifications subject to change without notice Page 2 ds-smc-series rev-a-1/11/2011
Standard Features for IFI SMC Solid State Series Amplifiers
VSWR Reflected Power Protection, the unit operates without damage or oscillation into any magnitude of phase or load impedance,
Open & Short Circuit Protection.
* Alternate Prime Power
(specify at time of order)
GPIB IEEE 488 & RS232 Remote Control
RF Sample Port on the Front Panel,
112R for rear panel
Internal Pre-amplification to obtain rated output power with an input level of 0 dBm or less.
Gain Control Local & Remote, 30dB range
RF Input/Output Connectors on the Front Panel,
118R for rear panel
Internal Systems Diagnostics & Status Indicators
Total/Operate Elapsed Time Metering in hours
RF Safety Interlock
Standard
Features:
Forward/Reflected Power Indication simultaneously on Front Panel display
IFI SMC Solid State Series Amplifier Specifications
Frequency Range: As Specified in Model Table
Rated Output Power: As Specified in Model Table
Gain @ Rated Power: As Specified in Model Table
Prime Power: As Required (Some are listed below)
Input/output Impedance: 50 ohms
RF Input/ Sample Connectors: Type N Female, unless specified otherwise
RF Output Connector:
Type N Female up to 1KW amps, SC or 7/16 available, 7/16 2KW-3KW amps
Other connectors available by request or specification
Input VSWR: 2.0:1
Output VSWR: 2.5:1
Operating Temp: 0º to 50º C
Non-operating Temp: -40º to 70º C (50,000 feet max)
Humidity: 95% without condensation
Altitude: 10,000 feet
Cooling System: Air cooled, self contained
Modulation: AM,FM, Pulse
Configuration: Rack Mount as specified in Model Table, or Rack/Cabinet Integrated
Spurious Outputs: <-60 dBc nominal
Harmonics: -20dBc minimum @ Linear Power
Standard Prime Powers:
100, 115, 120 VAC ±10% 50/60 Hz, single phase
220, 230, 240VAC ±10% 50/60 Hz, single phase
120/208 or 200/220/230/240VAC ±10% 50/60 Hz, three phase Wye or Delta power is available
200/220/230/240VAC ±10% 50/60 Hz, three phase Wye or Delta power is available
Special Prime Powers other then listed are subject to availability
Some Available Options for IFI SMC Solid State Series Amplifiers
Option 110-1E: GPIB IEEE-488 RS232 and Ethernet Remote Control
Option 110-2: GPIB IEEE-488 and RS 422 Remote Control
Option 110-3
GPIB IEEE-488 and RS 485 Remote Control
Option 113: Chassis slides for a 19" rack mounting
Option 118A: RF Input On Front Output On Rear
Option 118B:
RF Input On Rear Output On Front