Atec IFI-PT186-2KW - Manual

August 09 2012
IFI Pulse TWT Amplifier Specifications
IFI Model: PT186-2KW
Frequency Range: 6.5-18 GHz
Rated OP Pulse:
2000 Watts
1500 Watts minimum; (7.0-18GHz)
Gain @ rated power: 63 dB minimum
Prime Power: 120/240 VAC +/-10%, 50/60 Hz, Single Phase
Input/Output Impedance: 50 ohms (VSWR 2.0:1)
RF I/O Connectors: N-F / WRD650
Input/Output VSWR: 2.0:1
Pulse Input: BNC Female Front Panel
Pulse Width: 150 nsec nominal – 100 µsec maximum
PRF Range: 0 – 100 KHz
RF Pulse on/off ratio: 80 dB minimum
Duty Cycle: Up to 6%
Rise & Fall Time: 25 nsec maximum, 15 nsec nominal
Pulse to Pulse Jitter: <0.1 dB
Pulse Width Jitter: ±5 nsec maximum
Pulse Delay: 250 nsec maximum
Pulse to Pulse Stability: +/-0.1 dB
Temperature / Altitude: 0º to 50º C / Altitude:10,000 feet
Non-operating Temp: -20º to 70º C (50,000 feet max)
Weight: 90 pounds maximum, 70 pounds typical
Cooling System: Air cooled, self contained
Modulation: AM/FM/Pulse
Configuration:
10.5”H x 19”W x 25.25”D, ~70lbs (smaller units available consult factory)
Features: VSWR Protection against any output mismatch; will operate without damage or
oscillation against any magnitude and phase of source and load impedance.
GPIB IEEE 488 & RS232 Remote Control
Forward RF Sample Port on the Front Panel, Type N-F connector
Internal Pre-amplification to obtain rated output power with an input level of
0dBm or less.
RF Input Connector on the Front Panel
RF Output Connector on the Rear Panel
Internal Systems Diagnostics
Filament/Beam Elapsed Time Metering in hours
RF Safety Interlock, Type BNC Connector
Forward/Reflected Power Indication simultaneously on Front Panel display