Atec Fluke-80i-110S User Manual

Technical data

The ideal current probe for

Fluke ScopeMeter

Test Tools

80i-110s AC/DC

Current Probe

Technical Data

Accurate current measurements
become more and more critical
when troubleshooting electric,
electronic, and automotive cir-
cuits. The Fluke 80i-110s AC/DC
Current Probe is designed to
provide you with safe, high
accuracy measurements for a
wide range of applications.

The specially designed built-

in safety features such as the
600 V rms rating at the input
jaws, output cable, and BNC
connector enhance work safety
in industrial and commercial
power distribution systems.

The probe is shielded for

high noise immunity, to prevent
unwanted noise when trou-
bleshooting around noise gen-
erating devices like adjustable
speed motor drives and ignition
systems.

The 80i-110s accurately

reproduces current waveforms
as they occur. Connect the
clamp to a Fluke ScopeMeter
Test Tool or other waveform
recording device like a Fluke
Power Harmonics Analyzer, to
clearly see distorted waveforms
that result from non-linear loads
such as computers, adjustable
speed motor drives, and elec-
tronic ballasts for fluorescent
lighting.

Current clamps, not specifi-

cally designed for oscilloscopes,
may add distortion to the actual
signal present in the system

under test. This makes it diffi-
cult to get an accurate wave-
form measurement.

The wide measurement

range from 50 milliamps to 100
Amps with a high fidelity milli-
volt output gives you full
advantage of the high resolu-
tion oscilloscope displays. This
gives you the true picture of
your current situation, and
allows useful measurements as
low as 10 milliamps.

The broad band frequency

response of the Fluke 80i-110s
AC/DC Current Probe from dc to
100 kHz supports a wide range
of applications where the probe
can be used. The probe can be
used to track down leakage
currents discharging car batter-
ies or to measure dc currents
in an Uninterruptible Power

Supply (UPS), that uses a
battery backup system.

With its narrow jaw design,

the Fluke 80i-110s makes it
easy to take measurements in
tight spots.

Specifications

Electrical specifications

Current ranges:
0 to 10 A dc or ac peak
0 to 100 A dc or ac peak
Output signals:
10 A range: 100 mV/A
100 A range: 10 mV/A
Working voltage
(clamp jaws to ground):
600 V ac rms on Installation
Category II per IEC 1010-1
circuits.
300 V ac rms on Installation
Category III per IEC 1010-1
circuits.