Atec Solar-7406-1 - Manual

MODEL 7054-1 SPIKE GENERATOR 600 volts
SPECIFICATIONS
Spike Amplitude: Continuously adjustable from
10 volts to over 600 volts peak.
Repetition Rate: Continuously adjustable from
0.8 to 10 p.p.s.
Rise Time: Less than 1.0 microsecond, into 5 ohm
resistive load.
Spike Duration: Output falls to zero in
approximately 10 microseconds.
Spike Shape: See curve. Similar to Figure 19 of
MIL-STD-462.
Phase Adjustment: Spike position adjustable
from 0° to 360° periodically on 50, 60 or 400 Hz
sine wave.
Internal Impedance: Less than 0.5 ohm.
Output Power: More than 300 kw peak into
0.5 ohm load.
Power Current in Series Injection Mode:
Handles up to 25 amperes of current at power
frequencies.
Power Requirements: 115 volts 60 Hz,
1.6 amperes. (230 volts 50 Hz, 0.8 ampere
available. )
Size: Standard rack panel: 7" high, 19" wide, 12.75"
deep.(17.78 cm x 48.26 cm x 32.38 cm.)
AVAILABLE ACCESSORIES
Type 7332-1 Transient Pulse Transformer. Plugs
into SERIES output terminals of 7054-1A to
provide spike levels up to 600 volts, peak, into
6 ohm load.
Type 7406-1 Transient Pulse Transformer.
Plugs into SERIES output terminals of 7054-1 to
provide spike levels up to 1200 volts, peak, into
50 ohm load.
Type 8525-1 Noninductive Five Ohm Load.
Type 8527-1 Transient Pulse Transformer. Plugs
into SERIES output terminals of 7054-1 to provide
spike levels up to 2 KV, peak, into 50 ohm load.
TRANSIENT SHAPE INTO FIVE OHM LOAD
REQUIRED BY MIL-STD-461A/462
SERIES INJECTION ON A.C. LINE PARALLEL INJECTION ON D.C. LINE
24