Atec HAEFELY-pesd3010 User Manual
Page 2
Headquarters
Haefely Test AG
Lehenmattstrasse 353
CH-4052, Basel
Switzerland
+ 41 61 373 41 11
+ 41 61 373 45 99
Locate your local
sales representative at
www.haefelyEMC.com
North American Office
Hipotronics Inc.
Haefely EMC Division
1650 Route 22
Brewster, NY 10509
++1 845 279 3644 x264
++1 845 279 2467
Haefely has a policy of continuous product improvement. Therefore we reserve the right to change design and specification without notice.
PESD3010_2006-05-23.doc
Technical Specifications
Air Discharge Voltage 1 – 30kV
Voltage resolution
100 volt steps
Cont. Discharge Volt. 1 – 30kV
Discharge Polarity
Positive & Negative
Discharge Repetition
Single/0.1/0.2/1/2/5/10/20 Hz
Operating Modes
Single & Continuous
Discharge Counter
1 - 9999
Power Supply
85 – 264V 50/60Hz
Default RC-Network
150 pF / 330 Ohm
Power consumption
30VA
Weights and Dimensions (W x H x D, net weight)
PESD 3010 Gun
10 x 21 x 29 cm
1.5 kg
PESD 3010 Controller 17 x 10 x 28 cm
1.5 kg
Scope of Supply Art. No. 249963
Qty. 1
PESD 3010 ESD Generator
Qty. 1
Carrying case
Qty. 1
Control and Power supply unit
Qty. 1
Ground Cable
Qty. 1
Test Finger Air discharge
Qty. 1
Test Finger Contact discharge
Qty. 1
Polarity module
Qty. 1
Capacitor module 150 pF IEC 61000-4-2
Qty. 1
Resistor module 330 Ohm IEC 61000-4-2
Qty. 1
User Manual
Options & Accessories
Capacitor Modules Available with any value in the range
from 50 to 1000pF. Fit in PESD 3010
rear panel. The Controller automati-
cally shows the value in the LCD
Resistor Modules
Available with any value in the range
from 50 to 5000
Ω
. Fit in PESD 3010
rear panel. The system automatically
shows the value in the LCD display
VCP
Vertical Coupling Plane 0.5m x 0.5m,
for indirect application of the ESD.
Includes cable with 2 integrated
470 kOhm HV-Resistors
HCP
Horizontal Coupling Plane 1.6m x
0.8m for indirect application of the
ESD. Includes cable with 2 integrated
470 kOhm HV-Resistors
Remote Control
Fibre optical RS 232 interface for
remote control of ESD gun
Test Table
Made of wood without any metallic
parts, as required by IEC 61000-4-2
Verification Set
For wave shape verification according to
IEC/EN 61000-4-2. Includes 2 Ohm
Target, Attenuators, BNC Cable, user
manual
Capacitor, Resistor & Polarity Modules
ESD Test Table with VCP & HCP