Atec Kaelus-IPA-A Series - Manual (Page 2)

Battery power 25.9 VDC, 2500 mAH Li-ion battery packs (removable)
Battery operating time Depends on usage, 2 hr min. per battery pack
Battery charger Output: 29.4 VDC, 1.2 Amp
DESCRIPTION TX1 RANGE TX2 RANGE RX RANGE (PIM) RTF MODULE *
iPA-0707A 700MHz LOW/HIGH 728-731.5MHz 741-764MHz 698-716MHz; 776-802MHz RTF-1000A
iPA-0850A 850MHz 869MHz 879-894MHz 824-849MHz RTF-1000A
iPA-0900A GSM900 932.5-937.5MHz 949-960MHz 903-915MHz RTF-1000A
iPA-0901A EGSM900 925-935MHz 945-960MHz 880-915MHz RTF-1000A
iPA-1800A DCS1800 1805-1817.5MHz 1855-1880MHz 1730-1755MHz RTF-2000A
iPA-1900A PCS1900 1930-1937MHz 1965-1990MHz 1855-1880MHz RTF-2000A
iPA-1921A Dual Band PCS/ 1930-1950MHz 1970-1990MHz 1850-1910MHz RTF-2000A
AWS 1930-1950MHz 2110-2155MHz 1710-1755MHz
© 2013 Kaelus. All Rights Reserved. iPA_A_RevG_11.13
www.kaelus.com
|2|
TECHNICAL SPECIFICATIONS CONTINUED |
ELECTRICAL
Dimensions 14.5 x 9.4 x 6.3in (369 x 240 x 160mm)
Weight < 26lbs (12kg)
MECHANICAL
Operating temperature range -10°C to +45°C (+14°F to +113°F)
Storage temperature range -10°C to +60°C (+14°F to +140°F)
Ingress protection (IP) IP54. IP67 when enclosed in optional hard case
Relative humidity 5% to 95% RH non-condensing
Mechanical shock 40G shock rating
ENVIRONMENTAL
MODELS |
iPA rugged hoist position iPA shown with iAK-0060A ruggedized trans-
port case with full PIM testing accessories.
*Range to Fault is an optional accessory available for iPA test instruments
which enables users to measure distance to return loss faults as well as
distance to PIM faults. The RTF module is sold separately.
Dual Battery charger for standalone charging sold separately.
WARNING: Use of the portable PIM analyzer in a radiating mode, for example
when connected to an antenna not enclosed in an anechoic environment,
may be a violation of licensing regulations. Users should obtain permission
in advance from any licensed operators that might be affected by these tests.
Furthermore, radiating high RF power can pose a personnel risk.
Specifications subject to change without notice.
Receive band (100kHz steps) See model table
Measurement noise floor < -128dBm
Measurement range -50dBm to -128dBm
RECEIVER