Atec Acterna-MS1000-1200-1300D-1400 - Manual (Page 3)

3
SIGNAL LEVEL METERS
The results are displayed in a list indicating which
parameters are out of tolerance. If all levels are within
limits, a ✓ will show in the far right column. If any
parameter is out of tolerance an X will
be shown Pressing the cycle soft key provides more detail by
bringing up a list of all channels. Passing channels
have a ✓ in the right hand column Pressing the cycle soft key provides a detailed view of
which specific error is on the specific channel
Level measurement
All instruments provide a compre-
hensive single-channel display and
a multichannel display with pass/fail
indicators. The multichannel display
quickly and clearly indicates if all
channels are being received at the
subscriber’s drop at appropriate system
design levels.
Installation check
Pressing ✓ key provides an installation
status check, which allows technicians
to verify that all levels are within user-
defined limits. Up to four different
limits can be configured: tap, ground
block, subscriber drop, and custom.
This feature can be used to determine
if a subscriber connection meets
cable
network or government
specifications.
These results can be printed,
(MS-1200D, MS-1300D, MS-1400)
or downloaded to the PC for report
generation using JSDSU StealthWare™
Data Analysis Software (MS-1300D,
MS-1400).
The single channel display shows the video and audio
carrier levels and the difference between levels.
Compatible with dual sound and NICAM The full scan display shows all user-defined video
carriers. The unique limit check feature quickly checks
the results against user-defined analog (MS-1200D,
MS-1300D and MS-1400D) and digital limits (MS-1400) The six-channel scan shows six different user-defined
video carriers, with PASS/FAIL indicator for user-
defined limit