Atec Amplifier-Research-50WD1000 - Manual (Page 2)

Page 2 of 2
SPECIFICATIONS, MODEL 50WD1000
RATED OUTPUT POWER ...............................................50 watts minimum
INPUT FOR RATED OUTPUT..........................................1.0 milliwatt maximum
POWER OUTPUT @ 3dB COMPRESSION
Nominal ................................................................60
watts
Minimum ...............................................................40 watts
POWER OUTPUT @ 1dB COMPRESSION
Nominal ................................................................50 watts
Minimum ...............................................................30 watts
FLATNESS.....................................................................±1.0 dB typical
±1.5 dB maximum
FREQUENCY RESPONSE ...............................................DC-1000 MHz
(In two bands selected automatically or manually)
GAIN ...........................................................................47 dB minimum
INPUT IMPEDANCE.......................................................50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE ...................................................50 ohms, nominal
MISMATCH TOLERANCE* .............................................100% of rated output power. Will operate without damage or oscillation with
any magnitude and phase of source and load impedance.
* See Application Note #27
MODULATION CAPABILITY...........................................Will faithfully reproduce AM, FM, or pulse modulation appearing on the input
signal.
HARMONIC DISTORTION.............................................Minus 20 dBc maximum at 35 watts
THIRD ORDER INTERCEPT POINT ..................................56 dBm typical
PRIMARY POWER (selected automatically).......................90 to 132; 180 to 264 VAC
50/60 Hz, single phase
700 watts maximum
RF CONNECTORS ........................................................See Model Configuration
REMOTE CONTROL......................................................25 Pin Subminiature D on rear panel
COOLING....................................................................Forced air (self contained fans)
MODEL CONFIGURATION
MODEL RF INPUT RF OUTPUT WEIGHT HEIGHT
50WD1000 Type N female on front panel Type N female on front panel 29 Kg (64 lb) 50.3 x 24.9 x 45.7 cm
19.8 x 9.8 x 18.0 in
50WD1000M1 Type N female on rear panel Type N female on rear panel 29 Kg (64 lb) 50.3 x 24.9 x 45.7 cm
19.8 x 9.8 x 18.0 in
50WD1000M2 Same as 50WD1000 with enclosure removed for rack mounting 19.5 Kg (43 lb) 48.3 x 22.2 x 45.7 cm
19.0 x 8.75 x 18.0 in
50WD1000M3 Same as 50WD1000M1 with enclosure removed for rack mounting 19.5 Kg (43 lb) 48.3 x 22.2 x 45.7 cm
19.0 x 8.75 x 18.0 in