Atec Amplifier-Research-100W1000B - Manual (Page 2)

Page 2 of 2
SPECIFICATIONS, MODEL 100W1000B
RATED OUTPUT POWER ...............................................100 watts
INPUT FOR RATED OUTPUT..........................................1.0 milliwatt maximum
POWER OUTPUT @ 3dB compression
Nominal ................................................................123
watts
Minimum ...............................................................100 watts
POWER OUTPUT @ 1dB compression
Nominal ................................................................95
watts
Minimum ...............................................................75 watts
FLATNESS.....................................................................±2.0 dB maximum
1.5 dB typical
±0.8 dB with internal leveling
FREQUENCY RESPONSE ...............................................1-1000 MHz instantaneously
GAIN (at maximum setting) ...........................................50 dB minimum
GAIN ADJUSTMENT (continuous range).........................18 dB minimum
(4096 steps remote)
INPUT IMPEDANCE.......................................................50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE ...................................................50 ohms nominal
MISMATCH TOLERANCE * ............................................Will operate without damage or oscillation with any magnitude and phase of
source and load impedance. Will limit reflected power to 100 watts.
MODULATION CAPABILITY...........................................Will faithfully reproduce AM, FM, or pulse modulation appearing on the input
signal.
HARMONIC DISTORTION.............................................Minus 20 dBc maximum at 80 watts
THIRD ORDER INTERCEPT POINT ..................................58 dBm typical
RF POWER DISPLAY ......................................................0-200 watts
PRIMARY POWER (user must specify) ..............................90 - 264 VAC
40/400Hz, single phase
1200 watts maximum
CONNECTORS
RF..........................................................................See
Model Configurations
REMOTE INTERFACES
IEEE-488.............................................................24 pin female
RS-232 ...............................................................9 pin Subminiature D (female)
ALC & PULSE .........................................................Type BNC on front panel
SAFETY INTERLOCK .....................................................15 pin Subminiature D
COOLING....................................................................Forced air (self contained fans)
* See Application Note #27
MODEL CONFIGURATION
MODEL NUMBER RF INPUT RF OUTPUT WEIGHT SIZE (W x H x D)
100W1000B Type N female on front panel Type N female on front panel 40 Kg (88 lbs) 50.3 x 24.9 x 53.0 cm
19.8 x 9.8 x 21.1 in
100W1000BM1 Type N female on rear panel Type N female on rear panel 40 Kg (88 lbs) 50.3 x 24.9 x 53.0 cm
19.8 x 9.8 x 21.1 in
100W1000BM2 Same as 100W1000B with enclosure removed for rack mounting 30 Kg (66 lbs) 48.3 x 22.2 x 53.0 cm
19 x 8.75 x 21.1 in
100W1000BM3 Same as 100W1000BM1 with enclosure removed for rack mounting 30 Kg (66 lbs) 48.3 x 22.2 x 53.0 cm
19 x 8.75 x 21.1 in
100W1000BM4 Type N on front panel. Type N on rear panel. 40 Kg (88 lbs) 50.3 x 24.9 x 53.0 cm
19.8 x 9.8 x 21.1 in
100W1000BM5 Same as 100W1000BM2 with manual gain control disabled 30 Kg (66 lbs) 48.3 x 22.2 x 53.0 cm
19 x 8.75 x 21.1 in
100W1000BM6 See separate Specification Sheet for this model.