Atec Amplifier-Research-30W1000BM4 - Manual (Page 2)

Page 2 of 2
SPECIFICATIONS, MODEL 30W1000B
RATED OUTPUT POWER ............................................... 30 watts minimum
INPUT FOR RATED OUTPUT.......................................... 1.0 milliwatt maximum
POWER OUTPUT @ 3dB COMPRESSION
Nominal................................................................ 36
watts
Minimum............................................................... 30 watts
POWER OUTPUT @ 1dB COMPRESSION
Nominal................................................................ 27
watts
Minimum............................................................... 20 watts
FLATNESS .................................................................... ±1.0 dB typical
±1.5 dB maximum
FREQUENCY RESPONSE............................................... 1-1000 MHz instantaneously
GAIN (at maximum setting)........................................... 45 dB minimum
GAIN ADJUSTMENT (Continuous Range) ....................... 20 dB minimum (4096 steps remote)
INPUT IMPEDANCE ...................................................... 50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE................................................... 50 ohms, nominal
MISMATCH TOLERANCE * ............................................ 100% of rated power without foldback. Will operate without
damage or oscillation with any magnitude and phase of source
and load impedance.
MODULATION CAPABILITY .......................................... Will faithfully reproduce AM, FM, or pulse modulation appearing
on the input signal
HARMONIC DISTORTION ............................................ Minus 20 dBc maximum at 25 watts
THIRD ORDER INTERCEPT POINT.................................. 52 dBm typical
PRIMARY POWER (selected automatically) ...................... 90-132, 180-264 VAC
.................................................................................... 50/60 Hz, single phase
.................................................................................... 325 watts maximum
REMOTE INTERFACES................................................... IEEE-488, RS-232
CONNECTORS
RF ......................................................................... Type N female
REMOTE CONTROL
IEEE-488 ............................................................ 24 pin female
RS-232............................................................... 9 pin Subminiature D female
REMOTE INTERLOCK.................................................... 15 Pin Subminiature D
COOLING ................................................................... Forced air (self contained fans)
WEIGHT....................................................................... See Model Configurations
SIZE (WxHxD)........ ....................................................... See Model Configurations
* See Application Note #27
MODEL CONFIGURATIONS
MODEL RF INPUT RF OUTPUT WEIGHT SIZE (W x H x D)
30W1000B Type N female on front panel Type N female on front panel 20.5 kg (45.0 lb) 50.3 x 15.5 x 37.6 cm
19.8 x 6.1 x 14.8 in
30W1000BM1 Type N female on rear panel Type N female on rear panel 20.5 kg (45.0 lb) 50.3 x 15.5 x 37.6 cm
19.8 x 6.1 x 14.8 in
30W1000BM2 Same as 30W1000B with enclosure removed for rack mounting 16.0 kg (35.0 lb) 48.3 x 12.7 x 37.6 cm
19.0 x 5.0 x 14.8 in
30W1000BM3 Same as 30W1000BM1 with enclosure removed for rack
mounting
16.0 kg (35.0 lb) 48.3 x 12.7 x 37.6 cm
19.0 x 5.0 x 14.8 in
30W1000BM4 Same as 30W1000B – modified to operate when AC input applied
Local/Remote Switch from toggle to rocker switch
20.5 kg (45.0 lb) 50.3 x 15.5 x 37.6 cm
19.8 x 6.1 x 14.8 in
Type N female on front panel Type N female on rear panel 30W1000BM5
Enclosure removed for rack mounting
16.0 kg (35.0 lb) 48.3 x 12.7 x 37.6 cm
19.0 x 5.0 x 14.8 in