Atec Amplifier-Research-1000W1000D - Manual (Page 2)

Page 2 of 2
SPECIFICATIONS, 1000W1000D
RATED OUTPUT POWER ............................................... 1000 watts minimum
INPUT FOR RATED OUTPUT .......................................... 1.0 milliwatt maximum
POWER OUTPUT @ 3 dB compression
Nominal
................................................................ 1200 watts
Minimum ............................................................... 950 watts
POWER OUTPUT @ 1 dB compression
Nominal
................................................................ 950 watts
Minimum ............................................................... 700 watts
FLATNESS .....................................................................  2.0 dB
 0.8 dB with internal leveling
FREQUENCY RESPONSE ............................................... 80 - 1000 MHz instantaneously
GAIN (at maximum setting) ........................................... 60 dB minimum
GAIN ADJUSTMENT (continuous range) ......................... 18 dB minimum
INPUT IMPEDANCE ....................................................... 50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE ................................................... 50 ohms nominal
MISMATCH TOLERANCE* ............................................. 100% of rated power without foldback up to 6.0:1 mismatch above which may
limit to 600 watts reflected power. Will operate without damage or oscillation
with any magnitude and phase of source and load impedance.
*See Application Note #27
MODULATION CAPABILITY ........................................... Faithfully reproduces AM, FM, or Pulse modulation appearing on input signal.
HARMONIC DISTORTION ............................................. Minus 20 dBc maximum at 800 watts
THIRD ORDER INTERCEPT POINT .................................. 66 dBm typical
RF POWER METER ......................................................... 0 - 1200 watts full scale
PRIMARY POWER (specify voltage) .................................. 200 - 240 VAC, Delta Connected (4 wire)
360-435 VAC, Wye Connected (5 wire)
50/60 Hz, 3 phase
12kVA Maximum
CONNECTORS
RF
Input ................................................................. See Model Configurations
RF Output .............................................................. See Model Configurations
External Leveling Inputs .......................................... Type BNC female on front panel
Pulse Modulation Input ........................................... Type BNC female on front panel
Detected RF Output ................................................ Type BNC female on front panel
Remote Computer Interface .................................... 24 Pin female IEEE-488 (GPIB) and RS-232 connector on rear panel
Remote Computer Interface (fiber optic) .................. ST Conn Tx and Rx RS-232
Safety Interlock ....................................................... 15 pin Subminiature D on rear panel
Operate Interface ................................................... 27 pin Subminiature D on rear panel
COOLING .................................................................... Forced air (self contained fans), enters front and bottom
WEIGHT (approximate) ................................................. 340 kg (750 lb)
SIZE (W x H x D) ............................................................ 68.8 x 152.5 x 82.5 cm (27.1 x 60.0 x 32.5 in)
MODEL CONFIGURATIONS
Model RF input Connector RF Output Connectors Comments
1000W1000D Type N female rear panel Type 7/16 female on rear panel
1000W1000DM1 Type N female front panel Type 7/16 female on front panel
1000W1000DM2 Type N female rear panel Type 7/16 female on rear panel Forward and reverse sample
ports, Type N female on
front panel (-63 dBc)