Atec Amplifier-Research-30S1G3 - Manual (Page 2)

SPECIFICATIONS
Model 30S1G3
RATED POWER OUTPUT ......... 30 WATTS MINIMUM
INPUT FOR RATED OUTP UT ............ 1.0 MILLIWATT
MAXIMUM
POWER OUTPUT @ 3dB COMPRESSSION
Nominal ................................................................... 37 watts
Minimum ................................................................. 30 watts
POWER OUTPUT @ 1dB COMPRESSION
Nominal ................................................................... 32 watts
Minimum ................................................................. 25 watts
FLATNESS .................................................... ±1.5 dB typical
..................................................................... ±2.0 dB maximum
FREQUENCY RESPONSE ........................... 0.8 - 3.0 GHz
.......................................................................... instantaneously
GAIN (at maximum setting) ..................... 45 dB minimum
GAIN ADJUSTMENT.........................(Continuous Range)
.......................................................................... 10 dB minimum
................................................................... (4096 steps remote)
INPUT IMPEDANCE ............................................. 50 ohms
..............................................................VSWR 2.0:1 maximum
OUTPUT IMPEDANCE ........................ 50 ohms, nominal
MISMATCH TOLERANCE
100% of rated power without foldback. Will
operate without damage or oscillation with any
magnitude and phase of source and load
impedance.
(See Application Note #27)
MODULATION CAPABILIT Y
Will faithfully reproduce AM, FM, or pulse
Modulation appearing on the input signal
THIRD ORDER INTERCEPT
See chart. The third order intercept points for
this chart have been determined using two
tones spaced 1 MHz apart. This is typical for
W-CDMA systems. Closer tone spacing such as
60 kHz generally provides about a 1db to 3db
improvement in the IP.
HARMONIC DISTORTION ..........................Minus 20 dbc
...........................................................................max at 25 watts
SPURIOUS................................................Minus 73 dbc Typ.
PHASE LINEARITY ...................
± ± 1.0 deg/100 MHz, Typ
PRIMARY POWER......................(Selected Automatically)
................................................................90-132, 180-264 VAC
...............................................................50/60 Hz, single phase
...................................................................340 watts maximum
CONNECTORS
RF ............................................................ Type N female
REMOTE INTERFACES
IEEE-488 .............................................24 pin male
R S-232....................9 pin Subminiature D (male)
SAFETY INTERLOCK ................. 15 pin Subminiature D
COOLING ........................
Forced air (self contained fans )
MODEL CONFIGURATIONS
MODEL
NUMBER
RF INPUT RF OUTPUT WEIGHT SIZE (W x H x D)
30S1G3 Type N female on front panel Type N female on front panel 35.0 kg (77.0 lb)
50.3 x 20.3 x 54.6 cm
19.8 x 8.0 x 21.5 in
30S1G3M1 Type N female on rear panel Type N female on rear panel 35.0 kg (77.0 lb)
50.3 x 20.3 x 54.6 cm
19.8 x 8.0 x 21.5 in
30S1G3M2 Same as 30S1G3 with enclosure removed for rack mounting 25.6 kg (57.0 lb)
48.3 x 17.8 x 54.6 cm
19.0 x 7.0 x 21.5 in
30S1G3M3 Same as 30S1G3M1 with enclosure removed for rack mounting. 25.6 kg (57.0 lb)
48.3 x 17.8 x 54.6 cm
19.0 x 7.0 x 21.5 in