Atec AR-60S1G3 - Manual (Page 2)

Model 60S1G3
RATED POWER OUTPUT................ 60 watts minimum
INPUT FOR RATED OUTPUT................... 1.0 milliwatt
.......................................................................... maximum
POWER OUTPUT @ 3dB COMPRESSSION
Nominal............................................................ 70 watts
Minimum.......................................................... 60 watts
POWER OUTPUT @ 1dB COMPRESSION
Nominal............................................................ 60 watts
Minimum.......................................................... 50 watts
FLATNESS .............................................. ±1.5 dB typical
............................................................ ±2.0 dB maximum
FREQUENCY RESPONSE ....................... 0.8 - 3.0 GHz
................................................................. instantaneously
GAIN (at maximum setting) .................. 48 dB minimum
GAIN ADJUSTMENT..................... (Continuous Range)
................................................................. 10 dB minimum
........................................................... (4096 steps remote)
INPUT IMPEDANCE ........................................ 50 ohms
...................................................... VSWR 2.0:1 maximum
OUTPUT IMPEDANCE .................... 50 ohms, nominal
MISMATCH TOLERANCE
100% of rated power without foldback. Will
operate . without damage or oscillation with any
magnitude and phase of source and load
impedance.
(See Application Note #27)
MODULATION CAPABILITY
Will faithfully reproduce AM, FM, or pulse
Modulation appearing on the input signal
THIRD ORDER INTERCEPT
See chart. The third order intercept points for
this chart have been determined using two
tones spaced 1 MHz apart. This is typical for
W-CDMA systems. Closer tone spacing such as
60 kHz generally provides about a 1db to 3db
improvement in the IP.
HARMONIC DISTORTION.......................Minus 20 dbc
.................................................................. max at 50 watts
SPURIOUS ......................................... Minus 73 dbc Typ.
PHASE LINEARITY.................
± 1.0 deg/100 MHz, Typ
PRIMARY POWER ...................(Selected Automatically)
.........................................................90-132, 180-264 VAC
....................................................... 50/60 Hz, single phase
........................................................... 600 watts maximum
CONNECTORS
RF ..................................................... Type N female
REMOTE INTERFACES
IEEE-488..................................................24 pin
RS-232 ............................. 9 pin Subminiature D
SAFETY INTERLOCK .............. 15 pin Subminiature D
COOLING.....................
Forced air (self contained fans )
MODEL NUMBER RF INPUT RF OUTPUT WEIGHT SIZE(WxHxD
60S1G3 Type N female on front panel Type N female on
front panel 45 kg (100 lbs) 50.3 x 24.9 x 54.6 cm
19.8 x 9.8 x 21.5 in
60S1G3M1 Type N female on rear panel Type N female on
rear panel 45 kg (100 lbs) 50.3 x 24.9 x 54.6 cm
19.8 x 9.8 x 21.5 in
60S1G3M2 Same as 60S1G3
with enclosure removed for rack mounting
32 kg (71 lbs) 48.3 x 22.2 x 54.6 cm
19.0 x 8.75 x 21.5 in
60S1G3M3 Same as 60S1G3M1
with enclosure removed for rack mounting
32 kg (71 lbs) 48.3 x 22.2 x 54.6 cm
19.0 x 8.75 x 21.5 in
60S1G3M4 Same as 60S1G3M2 except the gain control knob is removed
and a lock is installed
32 kg (71 lbs) 48.3 x 22.2 x 54.6 cm
19.0 x 8.75 x 21.5 in
*60S1G3M5 Type N female on front panel Type N female on
front panel 45 kg (100 lbs) 50.3 x 24.9 x 54.6 cm
19.8 x 9.8 x 21.5 in
* The Gain Control can be used to optimize ACP performance.