Atec Amplifier-Research-300T2G8 - Manual (Page 2)

Page 2 of 3
SPECIFICATIONS, MODEL 300T2G8
POWER (fundamental), CW, @ OUTPUT CONNECTOR
Nominal ................................................................350 watts
Minimum ...............................................................300 watts
Linear @ 1 dB Compression ...................................75 watts minimum
FLATNESS.....................................................................±12 dB maximum, equalized for ±5 dB maximum at rated power
FREQUENCY RESPONSE ...............................................2.5-7.5 GHz instantaneously
INPUT FOR RATED OUTPUT..........................................1.0 milliwatt maximum
GAIN (at maximum setting) ...........................................55 dB minimum
GAIN ADJUSTMENT (continuous range).........................35 dB minimum
INPUT IMPEDANCE.......................................................50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE ...................................................50 ohms, VSWR 2.5:1 typical
MISMATCH TOLERANCE...............................................Output power foldback protection at reflected power exceeding 60 watts. Will
operate without damage or oscillation with any magnitude and phase of source
and load impedance. May oscillate with unshielded open due to coupling to
input. Should not be tested with connector off.
MODULATION CAPABILITY...........................................Will faithfully reproduce AM, FM, or pulse modulation appearing on the input
signal. AM peak envelope power limited to specified power.
VIDEO PULSE CAPABILITY
Pulse Width............................................................0.05 microseconds min
Pulse Rate (PRF)......................................................100 kHz max
RF Rise and Fall......................................................30 ns max (10 % to 90%)
Delay.....................................................................300 ns max from pulse input to RF 90%
Pulse Width Distortion.............................................± 30 ns (50% points of output pulse width compared to 50% point of input pulse
width)
NOISE POWER DENSITY
(pulse on) ..............................................................Minus 85 dBm/Hz (maximum); Minus 90 dBm/Hz (typical)
(pulse off) ..............................................................Minus 140 dBm/Hz (typical)
HARMONIC DISTORTION.............................................Minus 3.0 dBc maximum, Minus 4.5 dBc typical
PRIMARY POWER ..........................................................190-260 VAC
50/60 Hz single phase
3.0 KVA maximum
CONNECTORS
RF input .................................................................Type N female on rear panel
RF output ...............................................................Type N female on rear panel
RF output sample port ............................................Type N female on rear panel
GPIB......................................................................IEEE 488 (f) on rear panel
Interlock ................................................................DB-15 (f) on rear panel
Video.....................................................................BNC-female on rear panel
COOLING....................................................................Forced air (self contained fans), air entry and exit in rear.