Atec AH-Systems-PAM-0126 - Manual (Page 3)

A.H. Systems, inc.
Model PAM-0126 Preamplifier
SPECIFICATIONS
The PAM-0126 Preamplifier Specifications:
Power output ................................................................+10 dBm at 1 dB compression
Frequency Range ............................................................................. 20 MHz - 26 GHz
Maximum input for rated output ......................................................................-20 dBm
Gain ..................................................................................................................32.0 dB
Gain Flatness ............................................................................................... +/- 3.5 dB
Noise Figure................................................................................................4.2 dB Max
Modulation capability ............................................................ will reproduce AM, FM or
pulse modulation on the
input signal
Primary Power .................................................................................+15 VDC, 180 mA
RF Connectors.................................................................................... Type N (female)
Impedance .................................................................................. 50 ohm, < 2.5 VSWR
Weight ..................................................................................................1.1 lbs. / 0.5 kg
Size (W x H x D) .............................................................................3.75" x 2.5" x 6.25"
........................................................................... 95.3 x 63.5 x 158.7 mm
POWER SUPPLY
The model PAM-0126 is
supplied with an external power
supply that can be used on
110/120/220/240 VAC, 50/60
Hz, and supplies 15.0 VDC at
180 mA. The power supply has
a standard AC input connector
and uses a 2.5mm coax output
connector. An optional battery
source may be used for this unit.
GENERAL USE INSTRUCTIONS
Operation of the model PAM-
0126 low noise amplifier is quite
simple. The unit is turned on by
first plugging the phone type
plug from an external power
supply into the power input
connector. The power supply is
then plugged into the
appropriate line voltage supply.
The input signal is connected to
the jack marked “INPUT”. The
output signal is taken from the
jack marked “OUTPUT” and fed
to the desired amplifier or test
equipment. The preamplifier is
turned on by pulling out and
lifting the switch to the on
position, the Power indicator
LED will light. Please allow 15
minutes of warm up time to
allow the preamplifier to
stabilize. The input signal should
normally be at a level of –20
dBm or lower. Signal levels
greater than –20 dBm will drive
the amplifier into compression,
resulting in distortion of the
signal.
CAUTION:
The model PAM-0126
amplifier is not critical in
regards to source and load
VSWR and will remain
unconditionally stable with
any magnitude and phase of
source and load VSWR.
However, input signals
greater than -20 dBm can
damage the amplifier.
MAINTENANCE
Annual recalibration is
recommended to ensure reliable
and repeatable performance.
A.H. Systems experienced
technicians can recalibrate
almost any type or brand of
antenna.
For more information about our
calibration services or to place
an order for antenna calibration
visit our website at
http://www.AHSystems.com or
call 1(818) 998-0223.