Atec Com-Power-pap-501 - Manual

Com-Power PAP-501 Preamplifier, 10 MHz - 1000 MHz
Com-Power broadband high gain preamplifiers were designed for electromagnetic
interference (EMI) testing and certification. EMC test labs use preamplifiers to improve
sensitivity of the test system during EMI radiated emissions measurements. Without a
high gain preamplifier, signals picked by the antenna that have amplitudes below the
noise floor of the test system cannot be measured.
The preamplifier gain has minimum variations for the entire operating frequency range
for accurate emissions measurements. The Com-Power preamplifiers were primarily
intended for EMC applications. However, it can be used for other applications that
require signal amplification.
 Frequency: 10 MHz - 1000 MHz
 Gain: 20 dB
 Flatness: ± 2 dB
 Noise Figure: < 6 dB
 P1dB: +4 dBm
 VSWR: 1.3:1
 Impedance: 50 Ohms
 Max. DC Input: 2 VDC, 0 dBm
 Input/Output connector Type: BNC (f)
 Input Power: 6 VDC, 500 mA
 Dimensions: 83 x 42 x 25 mm (3.27 " x 1.65" x 0.985")
 Weight: 1 lb. (0.45 kg)
 Typical preamplifier PAP-501 gain: