Atec AE-Techron-7796HC - Manual (Page 2)

7796HC Datasheet Information subject to change. 5/4//11
AC Specifications
PEAK OUTPUT RMS OUTPUT
40mSec Pulse,
20% Duty Cycle
5 Minute,
100% Duty Cycle
1 Hour,
100% Duty Cycle
5 Minute,
100% Duty Cycle
1 Hour,
100% Duty Cycle
Ohms Volts Amps Volts Amps Volts Amps Volts Amps Volts Amps Watts
2 79 39 79 39 79 39 56 28 56 28 1540
1 56 56 55 55 55 55 39 39 39 39 1512
0.5 53 106 52 104 50 100 37 74 35 71 2499
0.25 40 157 38 152 35 139 27 107 25 98 2432
Input Characteristics
Balanced with Ground:
Three terminal barrier block connector
20k ohm differential
Unbalanced:
BNC connector, 10k ohm single ended
Gain:
Voltage Mode: 20 volts/volt
Current Mode: 20 amperes/volt
Residual Noise:
DC – 30 kHz: Less than 75 microvolts
DC – 100 kHz: Less than 1 millivolt
Slew Rate:
41 volts per microsecond
Display, Control, Status
Front Panel
LED Displays indicate:
Ready, Standby and Fault conditions
in the output stage
LCD Display:
Lists type of fault condition and gives
suggested corrective action
Soft Touch Switches for:
Run (Enable), Stop, Reset
User Configurable:
LCD display can be configured for up
to four simultaneous displays reporting
one, two or all four of the following:
Voltage Peak, Voltage RMS, Current
Peak, and Current RMS
Physical Characteristics
Chassis:
All aluminum construction designed for
stand-alone or rack-mounted operation
with black chassis; the amplifier
occupies five EIA 19-inch-wide rack
units
Weight:
103 lbs. (46.7 kg)
AC Power:
Three-phase, 208 VAC ±10%, 47-60 Hz, 30A AC service.
NOTE: 400 VAC version not available.
Operating Temperature:
10°C to 50°C (50°F to 122°F), Maximum Output Power de-rated
above 30°C (86°F).)
Humidity:
70% or less, non-condensing