Atec EMCO-ETS-Lindgren-3810-2-3816_2 - Manual (Page 2)

LISN / PLISN
2 22 22
Test Site Hardware
Applications
Model 3816/2 LISN
LISNs and PLISNs, also known as artificial
mains, are a valuable tool for EMC
engineers. In addition to their usual
function, LISNs can be used as a diagnostic
aid to evaluate EME designs. A paper
entitled, Using a LISN as an Electronic
System EMC Diagnostic Tool, by David
Staggs, describes how LISNs, normally
used for conducted measurement, can be
used to anticipate and reduce radiated
emissions. Mr. Staggs’ paper notes that
conducted resonances often have
correspondence to frequencies in the
radiated profile. By identifying and
reducing a conducted resonance, a
corresponding resonance in the radiated
profile is often reduced as well. Contact ETS
Sales for a copy of this paper.
MODEL TEST TYPE
FCC-15 VDE 0871 VDE 0876 EN55022
3810/2 CE CE CE CE
& 3816/2
Physical Specifications
MODEL WIDTH DEPTH HEIGHT WEIGHT
3810/2 22.2 cm 38.1 cm 15.2 cm 4.9 kg
& 3816/2 8.7 in 15.0 in 6.0 in 10.7 lb
MODEL LINES FREQUENCY POWER MAXIMUM MAXIMUM NETWORK POWER IN POWER OUT
PLUS RANGE SOURCE CURRENT VOLTAGE INDUCTANCE CONNECTOR CONNECTOR
GROUND FREQUENCY IMPEDANCE
Electrical Specifications
Operational Features
MODEL MANUAL ARTIFICIAL MANUAL MANUAL REMOTE
SWITCHED HAND SWITCHED SWITCHED SWITCHED
EARTHLINE CHOKE HIGH PASS FILTER TEST PORTS TEST PORTS
3810/2 " " "
3816/2 " " " " "
3810/2 NM 2 9kHz - 30 MHz 60 Hz 10 A 125 VAC Line to Ground 50
µ
H / 250
µ
H IEC power inlet NEMA ®
SH 50 Hz 10 A 250 VAC Line to Ground 50
Ω
with customer SCHUKO
®
BS 50 Hz 10 A 250 VAC Line to Ground specified plug British
3816/2 NM 2 9kHz - 30 MHz 60 Hz 15 A 125 VAC Line to Ground 50
µ
H / 250
µ
H Integral cord NEMA ®
SH 50 Hz 16 A 250 VAC Line to Ground 50
Ω
with SCHUKO
®
BS 50 Hz 16 A 250 VAC Line to Ground NEMA ® plug British
Model 3810/2, 3816/2
Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. Information presented is subject to change as product enhancements are made. Contact ETS Sales Department for current specifications. 3/00 - 2k S © 2000 ETS-EMCO REV A 3/00 - 2k S © 2000 ETS-EMCO REV A 3/00 - 2k S © 2000 ETS-EMCO REV A 3/00 - 2k S © 2000 ETS-EMCO REV A 3/00 - 2k S © 2000 ETS-EMCO REV A
USA:
Tel +1.512.835.4684
Fax +1.512.835.4729
FINLAND:
Tel +358.2.8383.300
Fax +358.2.8651.233
ONLINE:
[email protected]
http://www.emctest.com