Atec AR-MT06000 - Manual

081011
160 School House Road Souderton, PA 18964-9990 • 215-723-8181 • www.ar-worldwide.com Page 1 of 2
Model MT06000
Multistar™
Multi-tone RF Radiated Immunity System
80MHz–6GHz
Complete Testing Solutions to the following standards:
 EN/IEC 61000-4-3
 EN/IEC 60601-1-2
 EN 50130-4
 EN 61000-6-1/2
 EN 55024
The Model MT06000 (Multistar™ Multi-tone tester) is a state-of-the-art system
designed to test RF Radiated Immunity faster than ever before possible. By testing
multiple frequencies (tones) at once, test times can be reduced by a factor equivalent
to the number of tones selected. The number of tones is only limited by the signal
generator bandwidth (150MHz) and the size of the amplifier used with the system.
The MT06000 contains all the instruments needed to perform radiated immunity testing for IEC 61000-4-3 specification
except the required amplifiers, antennas and directional couplers. Amplifiers can be sized and selected based on your
required field levels and testing needs. Up to 4 RF amplifiers and directional couplers can be controlled and monitored
and power can be delivered to up to 4 antennas to generate the desired fields. The system contains a vector signal
generator, a vector signal analyzer, a RF pre-amplifier, a RF field probe and monitor, an RF switch matrix, and automated
radiated immunity test software. Everything is contained in a single housing, which eliminates setup issues. The software
includes automated routines to calibrate the field and maximize the speed of test (most tones possible) while still meeting
the Linearity and Harmonics requirements of the specification. In the event of a EUT failure, margin investigation
(thresholding) and traditional single tone testing can be performed causing a slowing of the test only in the areas of
concern. This system has the versatility needed for every test laboratory and equipment manufacturer while adding the
benefit of reduced test times and greater throughput.
Internal Test Specifications
IEC/EN 60601-1-2
IEC/EN 50130-4
IEC/EN 61326
IEC/EN 61000-6-1
IEC/EN 61000-6-2
CISPR 24/EN 55024
IEC 61000-4-3 procedure and
levels
Vector Signal Generator Specifications
Frequency range
Resolution
80
<4Hz
Power Out +10dBm
Modulation AM, FM, Pulse, Phase
Bandwidth 150MHz
Hardware Platform
PXIe
Vector Signal Analyzer Specifications
Frequency Range
Resolution 10MHz-6.6GHz
533nHz
Dynamic Range 80dB
Bandwidth 50Mhz
Hardware Platform
PXIe
RF Preamplifier Specifications
Frequency Range 50MHz-8GHz
Gain 26dB
Hardware Platform
PXIe
Field Monitor/Probe Spec
Channels 4
Probe 1
Type
Isotropic, Laser powered
Frequency 100kHz-6GHz
Range 0.5–800
V/m