Atec ARA-Technologies-PLA-130-A User Manual
Loop antennas
40
Phone: 301-937-9381 z
z
z
z
Fax: 301-937-2796 z
z
z
z
http://www.aratech-inc.com z
z
z
z
LOOP ANTENNAS
S
PECIFICATIONS
F
REQUENCY
R
ANGE
I
NPUT
P
OWER
I
MPEDANCE
S
IZE
C
ONNECTOR
T
YPE
L
OOP
B
ASE
ALA - 130/RS
1 kHz - 30 MHz
N/A
50 ohm
12" dia
6" x 4"
BNC Female
Active
ALA - 1030/RS 10 kHz - 30 MHz
N/A
50 ohm
24"x24"
6" x 4"
BNC Female
Active
PLA - 130/A
1 kHz - 30 MHz
1 kW
50 ohm
12" dia
6" x 4"
N Female
Passive
PLA - 205/B
20 Hz - 5 MHz
5 Watts
50 ohm
24"x24"
4" x 3"
BNC Female
Passive
PLA - 1030/B
10 kHz - 30 MHz
5 Watts
50 ohm
24"x24"
6" dia
BNC Female
Passive
PLA - 2050/A
20 Hz - 100 kHz
N/A
N/A
5.2" dia
3" x 2.5" BNC Female
Passive
PLH - 2050/A
20 Hz - 100 kHz
5 Amps
N/A
4.7" dia
4.7" dia
Banana Jack
Passive
Options
1. 10-foot RF cable with ferrite sleeves
3) Carrying Case
2. Tripod, TP-5 or TP-3
ALA-130/RS
PLA-130/A
ARA TECH offers two different models (ALA-130/A and ALA-
1030/B) of active loop antennas, three different models (PLA-
130/A, PLA-1030/B, and PLA-205/B) of passive loop
antennas, and two different pairs (
PLA-2050 & PLH-2050 and
PLA-451 & PLH-450) of loop sensors or field pick up coils and
radiating loops.
The
PLA-130/A and ALA-130/RS are designed for the
shielded room testing requirements per MIL-STD 285 and NSA
test standard 65-6. The
PLA-130/RS is capable of handling 1
kW input power while the
ALA-130/RS provides the dynamic
range required for shield room attenuation measurements. The
ALA-130/RS and PLA-130/A are sold together as a set known
as the
APL-130/RS.
The
PLA-1030/B is a single band passive loop antenna for
immunity or emission testing.
The
PLA-205/B is optimized for generating fields in the low
end of the frequency band from 20 Hz to 5 MHz. It can also be
used for emission testing at low frequencies. When used with
our extremely sensitive
BBH series receive antennas, it
provides the best combination for testing shielding
effectiveness in the 20 Hz to 5 MHz band.
All loop calibrations are made relative to a 50 ohm load. Active
and passive loops (except field generating coils
PLH-450 and
PLH-2050 and field pick-up coils PLA-2050 and PLA-451) are
individually calibrated in accordance with procedures specified
in IEEE-291 section 2.3.1.