Associated Equipment 12-1012 Quick Guide - Manual (Page 7)

7
Fig.2
Testing with load at 2,000 RPM:
This test is to check the alternator’s
behavior during loading.
38. Continue from the previous test, proceed to
the next step by pressing key will enter
to the display as follows.
39. You need to switch ON all loads (Head Lights,
Radio, Air-condition, Heater, etc) and press
enter key will display as follow:
40. After that press key again and it show
as below:
41. Press key will show the results of the
test:
42. To exit the program, pressing the
key at any moment will exit and return back to
the main menu screen.
43. If either minimum or maximum charging volts
are not within the voltage range limits then it
will display one of the screen as below (Fig. 3
& Fig. 4) and it will prompt you to check the
alternator system for the fault.
Fig.3
Fig.4
Switch ON all
the Electrical
Loads, then
press Enter
Rev engine up to
2,000 rpm
Continue this
rpm for 10
Max Charge:14.96V
Result: HIGH
Check Alt System
NO LOAD TEST
2000 RPM
Max 13.96 <13.5 V
Min 13.76 >12.5 V
Enter to proceed
13.89V
ChrgVolts: 13.96V
Result: Good
LOAD TEST
MinCharge:12.0V
Result: LOW
Check Belt/Alt
LOAD TEST
MaxCharge:13.06V
Result: LOW
Check Belt/Alt
LOAD TEST
Enter