Associated Equipment 12-1012 Quick Guide - Manual (Page 6)

6
29. During cranking when it detects that there is
no drop in voltage, it will display the following
screen:
30. To exit the program, pressing the key at any
moment will exit and return back to the main menu
screen.
Alternator Test
No load testing at 3000 RPM:
31. With engine OFF, place the vehicle
transmission in NEUTRAL for Manual and
PARK for Automatic and apply the parking
brake.
32. Pressing key once will scroll down to the
“Alternator Test”
33. Press key to continue and the display
will show:
34. Starts the engine then press key again and
the screen will prompt you as shown below:
35. After that press key again and it
show as below:
36. Press key will show the results of the
test:
37. If either minimum or maximum charging volts
are not within the voltage range limits then it
will display one of the screen as below (Fig. 1
& Fig. 2) and it will prompt you to check the
alternator system for the fault.
Fig. 1
Not detected...
Check connection
and test again
Cranking Test
Start Engine and
keep it running
Then press
Rev engine up to
3,000 rpm,
Continue this rpm
for 10 sec.
3000 RPM
Max 14.07 <15.0 V
Min 13.5 >13.3 V
Enter to proceed
13.96 V
ChargeVolts:13.96V
Result: Good
Enter to proceed
NO LOAD TEST
Min Charge:12.96V
Result: LOW
Check Alt System
NO LOAD TEST
Battery Test
Grounding Test
Starter Test
Alternator Test
Enter
Enter