Associated Equipment 12-1012 Quick Guide - Manual (Page 5)

5
21. If the measured resistance reading has gone
beyond the limits, then it will display the
screen as follows:
Note:
The above indicates that the ground contact
from the engine body to the battery is bad.
Check for rusted or corroded point of contacts.
If found, dismantle it for cleaning or replace
before fixing back. Repeat the test again after
fixing.
22. If you did not follow the right procedures
during the testing, it will display the results
as follows:
23. To exit the program, pressing the
key at any moment will exit and return back to
main menu screen
Starter Test
Note: Before performing this test, make sure
that the battery is fully charged and in
good condition.
24. With engine OFF, place the vehicle
transmission in NEUTRAL for Manual and
PARK for Automatic then apply the parking
brake.
25. Pressing key once will scroll down to the
“Starter Test”
26. Press key to continue and the display
will show as follows:
27. Switch the ignition key to ON and start
cranking the engine until it starts. Immediately
after that press key and the results will
show as follows :
28. If the voltage drop is too great during the
cranking, the tested results will display as
follows and will prompt you to check the
starter system.
12.65V
Crank engine now
Until it starts.
Then press Enter
Voltage:
MinVolts: 10.26V
VoltDrop: Normal
Result: OK
Cranking Test
Min Volts:7.96V
HIGH
Chk Starter Sys
Battery has aged
VoltDrop
High Resistance!
Clean contacts
and check cables
RESULTS:
Not detected...
Try again follow
right procedure
RESULTS:
Battery Test
Grounding Test
Starter Test
Alternator Test