Associated Equipment 12-1012 Quick Guide - Manual (Page 4)

4
Grounding Test
13. Pressing key once will scroll down to the
“Grounding Test”
14. Press key will proceed to the display
as follows.
15. Now transfer the BLACK tester clip from the
battery [-] terminal to a suitable position on
the engine or chassis body leaving the RED
clip still attached to the battery [+] terminal.
16. Now press key again and it will starts
analysing.
17. Once it has finished analysing, it will
prompt you with an instruction stating that
you have should unclamp the Black tester clip
from the engine or chassis body and transfer
to the battery negative [-] terminal within 20
seconds time limit if not the testing procedure
has to be repeated again as the gathered
data will be lost.
NOTE: 20 seconds is given to establish the
contact to the battery [-] post failing which the
data obtained earlier will be lost. Then you
need to repeat the whole testing procedures
again.
18. Once the Black clip is clamped onto the
battery [-] terminal, the Analyser display will
light up as shown.
19. Now you need to press key to proceed
and the display will show as follows
20. If the measured resistance reading is within
limits, then it will display as follows:
Battery Test
Starter Test
Alternator Test
Grounding Test
Analysing ...
Please Wait!
▌▌▌▌▌▌▌▌
OK
The measured
Resistance value
is within limits
Analysing ...
Please Wait!
▌▌▌▌▌▌▌▌
RESULTS:
Red clip to Batt
[+],Black clip
To Engine body.
Then press
Enter
Now clamp the
Black clip to
battery [-] post
20sec time limit
GROUNDING TEST:
Press Enter to
continue.