Alpha Technologies APU Control Module (ACM) User Manual

Page 12

Text mode
Original mode

018-340-B0-001 Rev. A

2.0 Installation,

Confi guration and System Interface, continued

2.2 ACM-96 and ACM-96G

2.2.1 A2304 Generator Controller Confi guration

1. The A2034 logic board is located in the electronics compartment of the APU
enclosure. Locate the 4-position Dip Switch and set switch 2 in the OFF position.
For the new confi guration, switches 1 and 3 should be on, and switches 2 and 4
should be off.

2. Remove the Y alarms harness and connect the 15 pin male mini mate-n-lock
connector directly to J2 of the 704-619 board.

3. Install provided alarm jumper to J4 of the A2034 logic board.

Fig. 2-2, A2304 Dip Switch Confi guration

Fig. 2-3, Y Alarms Harness

Fig. 2-4, Alarms Jumper