Alpha Technologies Cordex HP CXRF 48-12kW User Manual
Alpha modular switched mode rectifier system, Your power solutions partner
This manual is related to the following products:
Table of contents
Document Outline
- 010623b1e_Specs.pdf
- 0100002-S0b_12kW_specs.pdf
- 010600b1c_3.6kW_specs.pdf
- 9400000j0c_body.pdf
- Figure 1 — (a) Cordex 48-3.6kW (b)Cordex 48-4kW (c) Cordex 48-12kW switched mode rectifier
- Figure 2 — Rectifier front panel LEDs
- Figure 3 — Cordex CXCM4 model system controller front panel
- Figure 4 — Rectifier (or Converter) report screen
- Figure 5 — CAN termination selection and serial ports
- Figure 6 — Relay connections in the de-energized state
- Figure 7 — Digital input connection method
- Figure 8 — LVD override control and distribution alarm card
- Figure 9 — Fan assembly - screw removal
- Figure 10 — Fan assembly
- 1. Safety
- 2. Introduction
- 3. Rectifier Features
- 3.1 Front Panel
- 3.2 Rectifier Rear Panel
- 3.3 True Module Fail Alarm
- 3.4 Heat Dissipation
- 3.5 Over Temperature Protection
- 3.6 Wide AC Range
- 3.7 AC Inrush/Transient Suppression
- 3.8 Soft Start
- 3.9 Start Delay
- 3.10 Current Limit/Short Circuit Protection
- 3.11 Power Limiting
- 3.12 High Voltage Shutdown (HVSD)
- 3.13 Battery Eliminator Operation
- 4. Cordex System Controller (CXC)
- 5. Inspection
- 6. Installation
- 7. Wiring
- 8. System Startup
- 9. Rectifier States, Modes and Factory Defaults
- 10. Maintenance
- 11. Acronyms and Definitions
- 12. Warranty and Service Information