Alpha Technologies FlexPoint FPR1207-F - Technical Manual - Manual (Page 13)

3.0 Operation
3.1 Power On
1. Plug the unit into AC Power.
2. The green LED (2) should light. Additional LEDs on the front panel of the FPR1207-F
indicate the state of the system. Their functions are:
3. Verify the unit is functioning properly by unplugging it. After approximately 10
seconds the alarm should briefly sound.
4. Re-plug the unit into an AC power outlet. The battery status LED (1) will go out.
The unit is ready to be placed into service.
Fig. 3-1, Visual Status Indicators
R
Remove cover to access
silence alarm and battery
emergency use buttons.
1
Red LED: Replace battery
Red LED flashing: Battery missing / Low battery
Green LED: AC mode
Green LED flashing: Battery mode
2
1
2
1
2
13 010-344-B1-001 Rev. A (2/2014)