Alpha Technologies FlexPoint FPR1207-F - Technical Manual - Manual (Page 10)

2.0 Installation
2.1 Installation and Connection
Observe wiring harness polarity. Improperly connecting these wires can result in non-operation of
the unit, cause equipment damage, and void the warranty.
CAUTION!
Mounting holes for #12
hardware or equivalent
“Keyhole” slots for
easy mounting
1
2
Center of Gravity
(with battery installed)
Fig. 2-1, Unit Dimensions (in/mm), FPR1207-F as viewed from back
1. Unpack and inspect the unit.
2. The unit is designed for use in a sheltered environment protected from rain and snow.
Its operating temperature range is 0°C to 40°C / 32°F to 104°F (ambient). Install the unit
near an AC outlet.
3. Remove battery compartment door by pressing tab and opening door. Remove the door
and set aside until the installation process is complete.
4. Determine the necessary cable length to provide appropriate service loops between the
unit, the ONT, and the outlet. Plug the line cord into the receptacle on the back of the unit
and secure with a wire tie. DO NOT plug the unit into an AC outlet until the last step of the
installation procedure.
5. Mount the unit to the wall with #12 fasteners or equivalent, using the keyholes for easy
mounting. For applications (with 7.2Ah battery only) with higher seismic requirements,
use the round holes in the back of the unit for direct fastening to a stud or other structural
feature.
The power supply cord is used as the main disconnect device. Verify the socket/outlet is located/
installed near the equipment and is easily accessible
.
CAUTION!
7.8"
198mm
3.0"
76mm
2.5"
63.5mm
2.4"
61mm
3.0"
76mm
1.3"
33mm
8.7"
221mm
1
1
2
2
0.380"
9.7mm
.200"/5mm
0.250"
6.35mm
010-344-B1-001 Rev. A (2/2014) 10